Debian 4.0 with Intel ISP-2150G + Adaptec RAID 2100S
Hi and hello!
I have a little problem with installation of Etch on Intel ISP-2150G rack 2U server with PCI Adaptec 2100S RAID controller (2 disks in raid-1 matrix). The installation was good to the first reboot (successful disk partitioning and creating /dev/sda). After reboot "Waiting for root partition"
The kernel is checking I2O and failed. I try with acpi=off and also failed. I also try modprobe in BusyBox and failed. This hardware configuration works with Debian 3.1 kernel 2.4.27-686 and 2.6.8-686.
I2O subsystem v1.325
i2o: max drivers = 8
i2o: checking for PCI I2O controller...
ACPI: PCI Interrupt 0000:02:04.1[A] -> GSI 20 (level, low) -> IRQ 169
iop0: Controller found (0000:02:04.1)
(..)
iop0: Installed at IRQ 169
i2o: iop0: Activating I2O controller...
i2o: iop0: This may take a few minutes if (...)
iop0: HRT has 1 entries of 16 bytes each.
Adapter 00000012: TID 0000:[HPC*]:PCI 1: Bus 1 Device 22 Function 0
i2o: iop0: Controller added
Loading Adaptec I2O RAID: version 2.4 Build 5go
Detecting Adaptec I2O RAID controllers...
PCI: Unable to reserve mem region #1:200000@fc000000 for device 0000:02:04.1
dpti: adpt_config_hba: pci request region failed
Could not Init an I2O RAID device
Will not try to detect others.
I2O Block Device OSM v1.325
i2o/hda: i2o/hda1 (...) hda10
...
?"Waiting for root partition"?
...
************************************************************
(initramfs) cat /proc/modules
i2o_block 0
i2o_core 1
(initramfs) modprobe dpt_i2o
It returns a message like "PCI: Unable to reserve ..."
*************************************************************
Reply to: