Re: unbale to do dhclient after MAC change (ifconfig eth1 hw ether XX:XX..)
Jabka Atu(mashrom.head@gmail.com) is reported to have said:
> Wayne Topa wrote:
>
> > Jabka Atu(mashrom.head@gmail.com) is reported to have said:
> >
> >> Hello,..
> >>
> >> im using debian SID (64 bit) on Acer 5102.
> >> using bcm4318 wifi card.
> >> kernel 2.6.21-2-amd64
> >>
> >
<--<snip>-->
> i acdently left some data wrong (since when i was writing the thread i
> was complining maswifi)
> Im using BCM43XX module
>
> when reading dmesg i found :
>
> bcm43xx: PHY connected
> bcm43xx: Microcode rev 0x127, pl 0xe (2005-04-18 02:36:27)
> bcm43xx: Radio turned on
> bcm43xx: Radio enabled by hardware
> bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at:
> drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1484:bcm43xx_find_lopair()
> bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at:
> drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1484:bcm43xx_find_lopair()
> bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at:
> drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1484:bcm43xx_find_lopair()
> bcm43xx: Chip initialized
> bcm43xx: 32-bit DMA initialized
> bcm43xx: Keys cleared
> bcm43xx: Selected 802.11 core (phytype 2)
> bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at:
> drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1484:bcm43xx_find_lopair()
> bcm43xx: set security called, .level = 0, .enabled = 0, .encrypt = 0
>
> the strange thing that it works in 32 bit and not 64 bit
I have not recieved my 64 bit system yet, so don't know for sure. I
have read that some apps require that they be run in a 32 bit chroot.
Maybe try the guys on the debian-amd64 list can help you with that.
Good Luck! I look forward to hearing the answer to your problem.
>
<--<snip>-->
Wayne
--
To the systems programmer, users and applications serve only to provide
a test load.
_______________________________________________________
Reply to: