Re: Sarge->Etch upgrade breaks cupsys network printing - RESOLVED
On 04/17/2007 03:08 PM, Greg Folkert wrote:
> On Tue, 2007-04-17 at 12:45 -0400, Ralph Katz wrote:
>> No replies? Clear as mud? Let me rephrase my question! :)
>
> Make sure these check boxes are checked in the admin interface at
> http://localhost:631/admin/
>
> Share published printers connected to this system
> Allow remote administration
> Allow users to cancel any job (not just their own)
>
> Then wait for cups to reload the conf.
>
> in a few minutes the other machine will notice the proper url fo the
> printer and it will be able to work.
>
> Notice, something changed between Sarge and Etch as far as URLs for the
> printers. The Auto config stuff works better than forcing it.
>
> The only thing is you need to have your machine that has the real
> printer... make sure you define everything for it.
>
> To give you an example, my Epson RX600 was auto-setup properly by my
> Etch machine and my sid machine picked it up right away, as soon as I
> told my Etch machine to share ...
Works! Thank you, Greg. I didn't trust the web i/f, that was the
obvious thing I missed.
Regards,
Ralph
Reply to: