RE: SATA controller failure?
Any other changes? Patched the machine?
Try running modprobe and see if you can manually install the driver.
If not, reboot, does the sata card appear in the bios detection as the
machine posts?
If not, move it to another pci slot and do a escd reset in the bios and
try again....
Otherwise it tends to suggest the card has failed, however that is not
very common so I'd treat that as the least likely possibility until I
had checked everything else.
Regards
thing
-----Original Message-----
From: Anders Rillbert [mailto:rillbert@chello.se]
Sent: Friday, 18 November 2005 9:35 a.m.
To: debian-user@lists.debian.org
Subject: SATA controller failure?
Hi,
I have a dual boot system with a debian distro on an "ordinary" ide
drive and a Windows distro on a SATA drive.
Since yesterday morning my SATA drive can no longer be located by the
BIOS but my other ide drive is not affected.
I'm trying to figure out if it is the disk itself that has broke down or
if it is something wrong on the motherboard (I don't have access to
another machine with SATA connections to try the drive with).
I have attached two snippets from my syslog, one before, and one after
the disk failure. To me it looks like linux can not even find the SATA
controller, implying that something has broke down on the motherboard
(and the disk could hopefully still be ok). I'm not used to interpret
these logs though, so I'd appreciate any comments on them:
Syslog (outside the supplied snippets they are identical)
Before disk failure:
...
Nov 14 08:12:26 localhost kernel: eth0: Auto-negotiation Enabled.
Nov 14 08:12:26 localhost kernel: eth0: 100Mbps Full-duplex operation.
Nov 14 08:12:26 localhost kernel: libata version 1.02 loaded.
Nov 14 08:12:26 localhost kernel: ata_piix version 1.02
Nov 14 08:12:26 localhost kernel: ACPI: PCI interrupt 0000:00:1f.2[A] ->
GSI 18 (level, low) -> IRQ 185
Nov 14 08:12:26 localhost kernel: PCI: Setting latency timer of device
0000:00:1f.2 to 64
Nov 14 08:12:26 localhost kernel: ata1: SATA max UDMA/133 cmd 0xEC00 ctl
0xE802 bmdma 0xDC00 irq 185
Nov 14 08:12:26 localhost kernel: ata2: SATA max UDMA/133 cmd 0xE400 ctl
0xE002 bmdma 0xDC08 irq 185
Nov 14 08:12:26 localhost kernel: ata1: SATA port has no device.
Nov 14 08:12:26 localhost kernel: scsi0 : ata_piix
Nov 14 08:12:26 localhost kernel: ata2: dev 0 cfg 49:2f00 82:346b
83:7f01 84:4003 85:3c69 86:3c01 87:4003 88:20ff
Nov 14 08:12:26 localhost kernel: ata2: dev 0 ATA, max UDMA7, 234493056
sectors: lba48
Nov 14 08:12:26 localhost kernel: ata2: dev 0 configured for UDMA/133
Nov 14 08:12:26 localhost kernel: scsi1 : ata_piix
Nov 14 08:12:26 localhost kernel: Vendor: ATA Model: SAMSUNG
SP1213C Rev: SV10
Nov 14 08:12:26 localhost kernel: Type: Direct-Access
ANSI SCSI revision: 05
Nov 14 08:12:26 localhost kernel: SCSI device sda: 234493056 512-byte
hdwr sectors (120060 MB)
Nov 14 08:12:26 localhost kernel: SCSI device sda: drive cache: write
back
Nov 14 08:12:26 localhost kernel: /dev/scsi/host1/bus0/target0/lun0: p1
p2 < p5 p6 p7 >
Nov 14 08:12:26 localhost kernel: Attached scsi disk sda at scsi1,
channel 0, id 0, lun 0
Nov 14 08:12:26 localhost kernel: ACPI: PCI interrupt 0000:02:03.0[A] ->
GSI 19 (level, low) -> IRQ 177
Nov 14 08:12:26 localhost kernel: usbcore: registered new driver usbfs
Nov 14 08:12:26 localhost kernel: usbcore: registered new driver hub
Nov 14 08:12:26 localhost kernel: USB Universal Host Controller
Interface driver v2.2
Nov 14 08:12:26 localhost kernel: ACPI: PCI interrupt 0000:00:1d.0[A] ->
GSI 16 (level, low) -> IRQ 169
Nov 14 08:12:26 localhost kernel: uhci_hcd 0000:00:1d.0: Intel Corp.
82801EB/ER (ICH5/ICH5R) USB UHCI #1
Nov 14 08:12:26 localhost kernel: PCI: Setting latency timer of device
0000:00:1d.0 to 64
...
After disk failure:
...
Nov 16 07:07:55 localhost kernel: eth0: Auto-negotiation Enabled.
Nov 16 07:07:55 localhost kernel: eth0: 100Mbps Full-duplex operation.
Nov 16 07:07:55 localhost kernel: ACPI: PCI interrupt 0000:02:03.0[A] ->
GSI 19 (level, low) -> IRQ 177
Nov 16 07:07:55 localhost kernel: usbcore: registered new driver usbfs
Nov 16 07:07:55 localhost kernel: usbcore: registered new driver hub
Nov 16 07:07:55 localhost kernel: USB Universal Host Controller
Interface driver v2.2
Nov 16 07:07:55 localhost kernel: ACPI: PCI interrupt 0000:00:1d.0[A] ->
GSI 16 (level, low) -> IRQ 169
Nov 16 07:07:55 localhost kernel: uhci_hcd 0000:00:1d.0: Intel Corp.
82801EB/ER (ICH5/ICH5R) USB UHCI #1
Nov 16 07:07:55 localhost kernel: PCI: Setting latency timer of device
0000:00:1d.0 to 64
...
Regards
/Anders
--
To UNSUBSCRIBE, email to debian-user-REQUEST@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact
listmaster@lists.debian.org
Reply to: