mii-tool eth0 wierdness

[Simon Buchanan <nmc@orcon.net.nz>]

Hi There, i have a debian woody box that i am connected to via ssh, here 
is the ifconfig:

eth0      Link encap:Ethernet  HWaddr 00:50:FC:XX:XX:XX
          inet addr:203.109.xxx.xx  Bcast:203.109.xxx.xx 
Mask:255.255.255.xxx
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:4109 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1079 errors:8 dropped:0 overruns:0 carrier:16
          collisions:23 txqueuelen:100
          RX bytes:809755 (790.7 KiB)  TX bytes:169903 (165.9 KiB)
          Interrupt:16 Base address:0xa000

When i check the link with mii-tool i get the following response:

box:/etc# mii-tool -v eth0
eth0: 10 Mbit, half duplex, no link
  product info: vendor 00:00:00, model 0 rev 0
  basic mode:   10 Mbit, half duplex
  basic status: no link
  capabilities:
  advertising:

NO LINK? But im connected to the thing - and its connected to a 100Mbit 
hub... Is this a problem with the ethernet card?