Re: BroadCom net card (bcm4400 kernel module) and sarge installer

[Rua Haszard Morris <r.haszard@uws.edu.au>]

Thanks a lot; I actually already have the download (that same link was 
in my original post!!).

My question is how to I get this set up early in the install process so 
I can proceed with install as normal?

Alternatively, how do I set up the card now that I have a very minimal 
install & then proceed with base-config?

Sorry, I'm a total newbie really, not inept, just needing instructions.

Thanks all,
Rua HM.

>I'm a fellow newbie and had the same problem.  After getting a lot of
>> bad advice I finally had to install it from source.  I forgot where I
>> got it but the filename was bcm4400-2.0.5.something.
> http://broadcom.com/drivers/downloaddrivers.php
> voila, and GPL license too.

joost
--
Rua Haszard Morris
Software Engineer & Research Assistant
MARCS Auditory Laboratories
University of Western Sydney
http://marcs.uws.edu.au