Re: have used only 4904 out of 9729 cylinders, but "No free sectors available"
On Mon, 24 May 2004 01:47 pm, James Sinnamon wrote:
> Dear Debian users,
>
> During my installation of a 'testing' (I think) system I partitioned
> my 80Gig hard disk drive.
I have been told that I have not provided enough information.
My apologies to all.
I installed Debian 'testing' from a 110MB CDROM which I had
downloaded from my other machine. During the install, I partitioned
my 80Gig Hard disk (WDC WD800JB-00ETA, ATA
- see dmesg output below).
I only partitioned about roughly 45 Gig and planned to do
the rest at a later stage. When I did, using fdisk, and entered the
'n' for 'new partition' command, I got the message
No free sectors available
-- see further below.
Could someone please tell how to get around this problem?
TIA.
James
----------------------------------------------------------------------------------
1. dmesg output, show information about 80 Gig (Western Digital?)
Hard Disk Drive
hda: WDC WD800JB-00ETA0, ATA DISK drive
blk: queue f8826460, I/O limit 4095Mb (mask 0xffffffff)
hdc: CDU5211, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: attached ide-disk driver.
hda: 156301488 sectors (80026 MB) w/8192KiB Cache, CHS=9729/255/63, UD
MA(100)
Partition check:
/dev/ide/host0/bus0/target0/lun0: p1 p2 p3 p4 < p5 p6 p7 p8 p9 p10 >
Journalled Block Device driver loaded
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Adding Swap: 2096436k swap-space (priority -1)
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,10), internal journal
----------------------------------------------------------------------------------------
2. Output from fdisk
The number of cylinders for this disk is set to 9729.
There is nothing wrong with that, but this is larger than 1024,
and could in certain setups cause problems with:
1) software that runs at boot time (e.g., old versions of LILO)
2) booting and partitioning software from other OSs
(e.g., DOS FDISK, OS/2 FDISK)
Command (m for help):
Disk /dev/hda: 80.0 GB, 80026361856 bytes
255 heads, 63 sectors/track, 9729 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/hda1 1 522 4192933+ c W95 FAT32 (LBA
)
/dev/hda2 523 555 265072+ 83 Linux
/dev/hda3 556 1860 10482412+ 83 Linux
/dev/hda4 1861 4904 24450930 f W95 Ext'd (LBA
)
/dev/hda5 1861 2513 5245191 83 Linux
/dev/hda6 2514 3035 4192933+ 83 Linux
/dev/hda7 3036 3296 2096451 82 Linux swap
/dev/hda8 3297 3557 2096451 83 Linux
/dev/hda9 3558 3688 1052226 83 Linux
/dev/hda10 * 3689 4904 9767488+ 83 Linux
Command (m for help): No free sectors available
Command (m for help):
--
James Sinnamon
jps at westnet com auStralia
ph +61 412 319669, +61 2 95692123, +61 2 95726357
Reply to: