Re: Booting from 2nd HD with raid1
Hi,
On Thu, Feb 05, 2004 at 02:20:53PM +0100, Fr?d?ric Dreier wrote:
> Hi,
>
> I can't make lilo booting from my 2nd HD on my RAID1 installation
> (simulating 1st hd failure).. normal booting and booting from 1st HD is ok.
>
> lilo hangs after:
> LILO 2.22 .................................
>
>
> I tried different solutions from howto's and forums.. but I should make
> something wrong :-(
>
> My pc runs debian stable with 2xSamsung SATA HD, md0[hde1,hdg1] '/boot',
> md1[hde6,hdg6] '/'.
>
> My first question is : should I really make 2 lilo config? (actually i
> tried, without success)
>
> Should I turn off lba support? in bios? in lilo?
>
> Should I put geometry in lilo? does lba-aware-bios bypass this
> parameters? which geometry should I use? (fdisk give two different geom
> for both HD, and anotherone is shown in syslog...)
>
> Is there a way to 'debug' my lilo config, or should I go further with
> try-and-error ?
>
> Yeah.. lot of questions... sorry.
>
> Thanks for all you hints and help.
I never worked with RAID and SATA, but can you swap disks on interface?
--
Be happy!
Reply to: