Re: Permissions denied when enabling DMA

[Wayne Gemmell <wayneg@ananzi.co.za>]

On Saturday 02 August 2003 12:28, Andrew McGuinness wrote:
> Alvin Oga wrote:
> > hi wayn
> >
> > you need to make sure the the ide chipset
> > swupported by the kernel you're using
> >
My output for "lspci -v | more" is

	00:11.1 IDE interface: VIA Technologies, Inc. Bus Master IDE (rev 06) 			
(prog-if 8a [Master SecP PriP])
        Subsystem: VIA Technologies, Inc. Bus Master IDE
        Flags: bus master, medium devsel, latency 32, IRQ 16
        I/O ports at fc00 [size=16]
        Capabilities: [c0] Power Management version 2


> > - look at the motherboard, figure out what chipset
> >   and than check your kernel config options
> >
> > - try installing that module for the chipset
>
now in modconf the only ide modules are for ide-tape. 
Am I looking in the right place? Below is what I think is the relevant part of 
the kernel config file. 

Thanks
Wayne







CONFIG_BLK_DEV_IDE=y
CONFIG_BLK_DEV_IDEDISK=y
CONFIG_BLK_DEV_IDECD=y
CONFIG_BLK_DEV_IDETAPE=m
CONFIG_BLK_DEV_IDEFLOPPY=y
CONFIG_BLK_DEV_IDESCSI=m
CONFIG_BLK_DEV_CMD640=y
CONFIG_BLK_DEV_RZ1000=y
CONFIG_BLK_DEV_IDEPCI=y
CONFIG_IDEPCI_SHARE_IRQ=y
CONFIG_BLK_DEV_IDEDMA_PCI=y
CONFIG_BLK_DEV_ADMA=y
CONFIG_BLK_DEV_IDEDMA=y
CONFIG_BLK_DEV_AEC62XX=y
CONFIG_BLK_DEV_ALI15X3=y
CONFIG_BLK_DEV_AMD74XX=y
CONFIG_BLK_DEV_CMD64X=y
CONFIG_BLK_DEV_CS5530=y
CONFIG_BLK_DEV_HPT34X=y
CONFIG_BLK_DEV_HPT366=y
CONFIG_BLK_DEV_PIIX=y
CONFIG_BLK_DEV_PDC202XX=y
CONFIG_PDC202XX_BURST=y
CONFIG_BLK_DEV_SVWKS=y
CONFIG_BLK_DEV_SIS5513=y
CONFIG_BLK_DEV_SLC90E66=y
CONFIG_BLK_DEV_VIA82CXXX=y
CONFIG_IDE_CHIPSETS=y
CONFIG_BLK_DEV_4DRIVES=y
CONFIG_BLK_DEV_ALI14XX=y
CONFIG_BLK_DEV_DTC2278=y
CONFIG_BLK_DEV_HT6560B=y
CONFIG_BLK_DEV_PDC4030=y
CONFIG_BLK_DEV_QD65XX=y
CONFIG_BLK_DEV_UMC8672=y
CONFIG_BLK_DEV_IDE_MODES=y
CONFIG_BLK_DEV_ATARAID=y
CONFIG_BLK_DEV_ATARAID_PDC=y
CONFIG_BLK_DEV_ATARAID_HPT=y