Re: LILO on the second disk loaded by GRUB
"Dai" == Dai Yuwen <yuwen@micetek.com.cn> writes:
Dai> It seems GRUB had found lilo on /dev/hdd7. But error message
Dai> was displayed: L 01 01 ...
Please read the docs in /usr/share/doc/lilo.
>From Manual.txt.gz
L <error> ... The first stage boot loader has been loaded and started,
but it can't load the second stage boot loader. The two-digit error
codes indicate the type of problem. (See also section "Disk error
codes".) This condition usually indicates a media failure or a geometry
mismatch (e.g. bad disk parameters, see section "Disk geometry").
0x01 "Illegal command". This shouldn't happen, but if it does, it may
indicate an attempt to access a disk which is not supported by the
BIOS. See also "Warning: BIOS drive 0x<number> may not be accessible"
in section "Warnings".
The file README.common.problems has a few good hints to.
Cheers!
Shyamal
Reply to: