Re: Linksys LNE100TX ethernet lan card

[iehrenwald@earthlink.net]

>    So the long and the short of it is, I'm looking for anyone who might
> have installed this card and gotten it running on a debian box,

lspci -v:

00:0b.0 Ethernet controller: Lite-On Communications Inc LNE100TX Fast
Ethernet Adapter (rev 25)
        Subsystem: Lite-On Communications Inc: Unknown device c001
        Flags: bus master, stepping, medium devsel, latency 32, IRQ 18
        I/O ports at c400
        Memory at dd001000 (32-bit, non-prefetchable)
        Capabilities: <available only to root>

ifconfig:

eth0      Link encap:Ethernet  HWaddr 00:A0:CC:E1:4D:12  
          inet addr:192.168.1.1  Bcast:192.168.1.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:720 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100 
          Interrupt:18 Base address:0xc400 

/proc/interrupts:

 18:        349        369   IO-APIC-level  eth0


I didn't have to do anything special to the card.  I just plugged it in
and selected "DECchip Tulip (dc21x4x) PCI support" in the kernel
(2.2.16) config options.  You might want to hunt around in your BIOS
settings and see what you have for PCI Options.  Maybe you can
force-assign an IRQ to the card?

		Ian