improprer network config
debs,
mistakenly, i put the kabosh on "local" printing due to
my inept networking attempt. here's what i get from an
"lpr":
Script started on Tue Aug 22 11:06:42 2000 bt@1NET:~$
uname -a¦lpr Status Information: sending job
'bt@1NET+222' to lp@localhost connecting to
'localhost', attempt 1 cannot open connection to
localhost - Network is unreachable Make sure LPD server
is running on the server job 'bt@1NET+222' transfer to
lp@localhost failed bt@1NET:~$ exit Script done on Tue
Aug 22 11:06:55 2000
clueless, i don't know how i did it, nor do i know what
it means, but i seem to be trying to print at
"lp@localhost." in in any event, i want to get my
printing back and deal with networking after i get some
"local" print jobs out.
if it matters, here's my "boot" re eth0:
~$ dmesg
[snip]
Script started on Tue Aug 22 11:05:35 2000 bt@1NET:~$
dmesg 3c59x.c:v0.99H 27May00 Donald Becker
http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
eth0: 3Com 3c905C Tornado at 0x1400,
00:01:03:1a:41:3f, IRQ 11 8K byte-wide RAM 5:3 Rx:Tx
split, autoselect/Autonegotiate interface. MII
transceiver found at address 24, status 782d.
Enabling bus-master transmits and whole-frame receives.
Sending DHCP and RARP requests ... timed out!
IP-Config: Reopening network devices... Sending DHCP
and RARP requests ...<7>eth0: Transmit error, Tx status
register 82. timed out! IP-Config: Reopening network
devices... Sending DHCP and RARP requests ...<7>eth0:
Transmit error, Tx status register 82. timed out!
[snip] PPP BSD Compression module registered rpc.statd
forgot to set AF_INET in udp sendmsg. Fix it! RPC:
sendmsg returned error 101 RPC: sendmsg returned error
101 RPC: sendmsg returned error 101 RPC: sendmsg
returned error 101 portmap: server localhost not
responding, timed out RPC: sendmsg returned error 101
RPC: sendmsg returned error 101 RPC: sendmsg returned
error 101 RPC: sendmsg returned error 101 portmap:
server localhost not responding, timed out lockd_up:
makesock failed, error=-5 RPC: sendmsg returned error
101 RPC: sendmsg returned error 101 RPC: sendmsg
returned error 101 RPC: sendmsg returned error 101
portmap: server localhost not responding, timed out
bt@1NET:~$ quit bash: quit: command not found
do i need to re-roll the kernel to exclude the
networking parameters?
what networking file(s) could i have mucked up?
other than, "try harder next
time"--muhahaha--...suggestions?
ia, t.
bentley taylor.
(potato on 2.2.16)
//
Reply to: