Re: stty-question
Quoting Johann Spies (jhspies@ether.adept.co.za):
> If I use stty to configure a serial port, will the settings be the
> same after a reboot? Or do I have to put the settings in some init
> file similar to /etc/rc.boot/0setserial.
I think you'll find that even reloading the serial module will
reset the port, so if you do it with an initialisation script,
make sure the module is loaded from /etc/modules and not on
demand, and either use rc.boot (but that's now deprecated) or
make sure the S number is greater than 20 for the stty script.
Cheers,
--
Email: d.wright@open.ac.uk Tel: +44 1908 653 739 Fax: +44 1908 655 151
Snail: David Wright, Earth Science Dept., Milton Keynes, England, MK7 6AA
Disclaimer: These addresses are only for reaching me, and do not signify
official stationery. Views expressed here are either my own or plagiarised.
Reply to: