Installing Slink
Hi,
For those who aren't aware of it. When upgrading or installing from Hamm
to Slink you start with the binary disk 1 to boot-up on a new installation.
After getting the system running, use dselect to install the rest of the
system. In slink, you have to put the 2nd CD in first and then do
"Access", "Update", "Select", then install. You have to put the 2nd CD in
first so that all the packages can be picked up by dselect. If you put in
the first CD as I did the first time around, dselect will only pick up 1150
packages which is incomplete and you don't get to switch CD during
installation if you do this. On the other hand if you put the 2nd CD in
first then use "Install" in dselect it will tell you to put in whatever CD
is needed when it does the installation of the packages.
Shawn
Reply to: