Re: System won't boot, "lilo.conf" problem
Ok, this is from the manual on lilo:
LI The first stage boot loader was able to load the second stage boot
loader, but has failed to execute it. This can either be caused by a
geometry mismatch or by moving /boot/boot.b without running the map
installer.
Not sure how to help you, but maybe this explains a little bit what the
problem could be.
Could send the whole file if you need it.
In the mean time, use a Windows start disk to
fdisk /mbr
(Hope your BIOS does a A: C: boot procedure and searches for A: on a boot,
if not, set it up like that)
WHich will restore the original master boot record on the C drive so you
can boot Windows. Use Linux rescue floppy which you should have to get
in and perhaps rerun lilo, just make sure that all your compinents are in
place, like boot=/boot/.....
Andrew
____________________________________________________________________
Never include a comment that will help | Andrew Ivanov
someone else understand your code. | c680789@showme.missouri.edu
If they understand it, they don't | ICQ: 12402354
need you. |
Reply to: