Re: tape drive
On Wed, 8 Apr 1998, dpk wrote:
> I have an exabyte 8mm tape drive. I have compiled in scsi support,
> and scsi tape drive support into the kernel. It shows up in dmesg:
>
> Vendor: EXABYTE Model: EXB-8200 Rev: 2618
> Type: Sequential-Access ANSI SCSI revision: 01
>
> however, a device is not assigned to the drive. How do I tell which
> device it is? I looked at the SCSI HOWTO and it didn't say much
> about them except for that exabyte tape drives are supported. I also
> tried a few of the defaults without success.
>
> Dennis
should be /dev/nst0 for non-rewinding access and /dev/st0 for rewinding
---
Heute ist nicht alle Tage, ich komme wieder, keine Frage!!!
Joerg
--
To UNSUBSCRIBE, email to debian-user-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: