Re: How to configure dhcpcd?
Tried it, but it doesn't work... However, I am using an alpha driver for
an eepro100.
My /etc/dhcpc/config file looks like this:
-----------------------
(tao)hnine:/etc/dhcpc[523]$ cat config
# List here the interface that the dhcpcd daemon should use.
# The default is to assign an IP address to eth0.
# If you want to disable the daemon, enter "none" here.
IFACE=eth0
(tao)hnine:/etc/dhcpc[524]$
-----------------------
However, when I run the daemon (forcibly in the foreground) I get:
-----------------------
(tao)hnine:/etc[521]$ dhcpcd -d
no DHCPOFFER messages
(tao)hnine:/etc[522]$
-----------------------
The ifconfig output looks like this:
-----------------------
(tao)hnine:/etc[517]$ ifconfig eth0 up
(tao)hnine:/etc[518]$ ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
RX packets:115 errors:0 dropped:0 overruns:0
TX packets:115 errors:0 dropped:0 overruns:0
sl0 Link encap:Serial Line IP
inet addr:127.0.0.3 P-t-P:127.0.0.2 Mask:255.255.255.0
UP POINTOPOINT RUNNING MTU:256 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0
TX packets:49 errors:0 dropped:0 overruns:0
eth0 Link encap:10Mbps Ethernet HWaddr 00:A0:C9:27:06:DD
inet addr:0.0.0.0 Bcast:0.0.0.0 Mask:0.0.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0
TX packets:0 errors:0 dropped:0 overruns:0
Interrupt:9 Base address:0xff40
(tao)hnine:/etc[519]$
----------------------
Don't know what to do ... :-(
Any help is appreciated. Thanks.
-- Harmon
--
TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to
debian-user-request@lists.debian.org .
Trouble? e-mail to templin@bucknell.edu .
Reply to: