Merhaba,
Dediğiniz şu parametre ile alakalı olabilir. Deneyin isterseniz. Bu
arada benim dediğim parametreler gmplayer ile çalışıyor mu emin değilim.
-autosync <factor>
Gradually adjusts the A/V sync based on audio delay
measurements. Specifying -autosync 0, the default, will cause
frame timing to be based entirely on audio delay measurements.
Specifying -autosync 1 will do the same, but will subtly change
the A/V correction algorithm. An uneven video framerate in a
movie which plays fine with -nosound can often be helped by
setting this to an integer value greater than 1. The higher the
value, the closer the timing will be to -nosound. Try -au‐
tosync 30 to smooth out problems with sound drivers which do not
implement a perfect audio delay measurement. With this value,
if large A/V sync offsets occur, they will only take about
1 or 2 seconds to settle out. This delay in reaction time to
sudden A/V offsets should be the only side-effect of turning
this option on, for all sound drivers.
On Mon, 2005-05-16 at 22:28 +0300, Fatih ARSLAN wrote:
> Dediginiz üc secenegi de denedim, ama sonuc ayni.
> Top yazip da baktim, film izlerken %10 luk bir cpu harcamasi vardir.
> Ben bir arkadasima sordum da, dediki a/v sync diye bir ayar varmis.
> Yani ses/film ayari, bunu ben ayarlardan aradim bulamadim.
>
> Birde ben mplayer, gmplayer yazarak gui olarak calistiriyorum.
> Yani herhalde bundan kaynaklanmiyor
>
> Saygilar
--
Can Burak Çilingir
g'nin üzerinde
t, altında b
vardır. ta
ki keymap'i
değiştirene
kadar...
Attachment:
signature.asc
Description: This is a digitally signed message part