Re: GRUB + SATA +IDE
Jag gjorde en lite halvful sak bara för att testa om det gick.
Jag drog ur SATA-kabeln, startade datorn och slog på RAID-stödet i BIOS.
Nu dök GRUB upp, då pluggade jag i SATA-kabeln och drog igång Linux.
Det är nog inte meningen att man ska göra såhär...
Fick lite läsning mha dmesg:
VIA8237SATA: chipset revision 128
VIA8237SATA: 100% native mode on irq 20
ide2: BM-DMA at 0xc000-0xc007, BIOS settings: hde:pio, hdf:pio
ide3: BM-DMA at 0xc008-0xc00f, BIOS settings: hdg:pio, hdh:pio
hde: Maxtor 6Y080M0, ATA DISK drive
Using anticipatory io scheduler
ide2 at 0xb000-0xb007,0xb402 on irq 20
VP_IDE: IDE controller at PCI slot 0000:00:0f.1
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt8237 (rev 00) IDE UDMA133 controller on pci0000:00:0f.1
ide0: BM-DMA at 0xc800-0xc807, BIOS settings: hda:pio, hdb:pio
ide1: BM-DMA at 0xc808-0xc80f, BIOS settings: hdc:pio, hdd:pio
hda: Maxtor 6Y080P0, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hde: max request size: 128KiB
hde: 160086528 sectors (81964 MB) w/7936KiB Cache, CHS=65535/16/63, (U)DMA
/dev/ide/host2/bus0/target0/lun0:<4>hde: dma_timer_expiry: dma status
== 0x21
hde: DMA timeout error
hde: dma timeout error: status=0xd0 { Busy }
hde: DMA disabled
ide2: reset timed-out, status=0xd0
hde: status timeout: status=0xd0 { Busy }
hde: drive not ready for command
ide2: reset timed-out, status=0xd0
end_request: I/O error, dev hde, sector 0
Buffer I/O error on device hde, logical block 0
end_request: I/O error, dev hde, sector 0
Buffer I/O error on device hde, logical block 0
unable to read partition table
Reply to: