Lo malo es que bootlogd esta desactivado por defecto y dmesg no es especifico.Bueno, Gracias por la ayuda y los comentarios. Estoy conectado a la red cableada nuevamente.
Saludos2014-02-05 Maykel Franco <maykeldebian@gmail.com>:
2014-02-05 Ricardo Zúñiga <ceaerrepe@gmail.com>:Anoche estube trabajando hasta tarde y me qede dormido con el encendido en la mañana al levantarme solo cerre la tapa y al llegar a la oficina ya estaba encendido. Quizas sea un tema de "Hibernación" que desactiva las eth0 o entran en conflicto.Vamos que no se quemó ni nada por el estilo
# ifconfig -a
eth0 Link encap:Ethernet HWaddr b8:70:f4:27:2b:a9
inet6 addr: fe80::ba70:f4ff:fe27:2ba9/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:1488 errors:0 dropped:0 overruns:0 frame:0
TX packets:43 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:119938 (117.1 KiB) TX bytes:9199 (8.9 KiB)
Interrupt:40 Base address:0x6000RX packets:34 errors:0 dropped:0 overruns:0 frame:0
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
TX packets:34 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2348 (2.2 KiB) TX bytes:2348 (2.2 KiB)RX packets:151 errors:0 dropped:0 overruns:0 frame:2017
wlan0 Link encap:Ethernet HWaddr ac:81:12:80:13:82
inet addr:200.0.0.80 Bcast:200.0.0.255 Mask:255.255.255.0
inet6 addr: fe80::ae81:12ff:fe80:1382/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
TX packets:100 errors:21 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:14144 (13.8 KiB) TX bytes:22554 (22.0 KiB)
Interrupt:17Camaleón no uso windows, solo debian. Desactive y active la red desde la BIOS y nada.Pero.....Elimine "/etc/udev/rules.d/70-persistent-net.rules" y "APAGUE" el notebook, al volver a encenderlo volvio a aparecer, ahora me dice que no esta gestionado, pero ya aparecio (Volvio de sus cortas vacaciones).
2014-02-05 Debian GMail <javier.debian.bb.ar@gmail.com>:
El 05/02/14 10:47, Ricardo Zúñiga escribió:Si la placa es "on-board", se te quemó.
Saludos lista, les comento lo que me paso:
Vaya sorpresa me eh dado esta mañana, Desaparecio la interfaz de red
cableada eth0.
# dmesg | grep -i eth
[ 18.761560] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
Quitandole la sentencia -i no arroja resultado, pero con lspci no la veo:
# lspci
00:00.0 Host bridge: Intel Corporation Core Processor DRAM Controller
(rev 02)
00:02.0 VGA compatible controller: Intel Corporation Core Processor
Integrated Graphics Controller (rev 02)
00:16.0 Communication controller: Intel Corporation 5 Series/3400 Series
Chipset HECI Controller (rev 06)
00:1a.0 USB controller: Intel Corporation 5 Series/3400 Series Chipset
USB2 Enhanced Host Controller (rev 05)
00:1b.0 Audio device: Intel Corporation 5 Series/3400 Series Chipset
High Definition Audio (rev 05)
00:1c.0 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI
Express Root Port 1 (rev 05)
00:1c.1 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI
Express Root Port 2 (rev 05)
00:1c.4 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI
Express Root Port 5 (rev 05)
00:1d.0 USB controller: Intel Corporation 5 Series/3400 Series Chipset
USB2 Enhanced Host Controller (rev 05)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev a5)
00:1f.0 ISA bridge: Intel Corporation Mobile 5 Series Chipset LPC
Interface Controller (rev 05)
00:1f.2 SATA controller: Intel Corporation 5 Series/3400 Series Chipset
4 port SATA AHCI Controller (rev 05)
00:1f.3 SMBus: Intel Corporation 5 Series/3400 Series Chipset SMBus
Controller (rev 05)
00:1f.6 Signal processing controller: Intel Corporation 5 Series/3400
Series Chipset Thermal Subsystem (rev 05)
05:00.0 Network controller: Broadcom Corporation BCM4313 802.11b/g/n
Wireless LAN Controller (rev 01)
ff:00.0 Host bridge: Intel Corporation Core Processor QuickPath
Architecture Generic Non-core Registers (rev 02)
ff:00.1 Host bridge: Intel Corporation Core Processor QuickPath
Architecture System Address Decoder (rev 02)
ff:02.0 Host bridge: Intel Corporation Core Processor QPI Link 0 (rev 02)
ff:02.1 Host bridge: Intel Corporation Core Processor QPI Physical 0
(rev 02)
ff:02.2 Host bridge: Intel Corporation Core Processor Reserved (rev 02)
ff:02.3 Host bridge: Intel Corporation Core Processor Reserved (rev 02)
Agregue la interfaz en /etc/network/interfaces, pero al querer levantarla
# /etc/init.d/networking restart
[....] Running /etc/init.d/networking restart is deprecated because it
may not re-enable some inte[warns ... (warning).
[....] Reconfiguring network interfaces...Internet Systems Consortium
DHCP Client 4.2.2
Copyright 2004-2011 Internet Systems Consortium.
All rights reserved.
For info, please visit https://www.isc.org/software/dhcp/
Cannot find device "eth0"
Bind socket to interface: No such device
Failed to bring up eth0.
done.
No sé por donde mas seguir no se me ocurre nada.
Atento a cualquier comentario
Saludos
--
Atte.
Ricardo G. Zúñiga Bauer
Analista programador
Sitio web: http://ceaerrepe.com.ar
User Linux: #455331
Si es PCI, está floja.
Sacala, limipiá con contamatic, y volvé a colocarla
JAPArchive: [🔎] 52F25AC2.4020408@gmail.com" target="_blank">http://lists.debian.org/[🔎] 52F25AC2.4020408@gmail.com
--
To UNSUBSCRIBE, email to debian-user-spanish-REQUEST@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
--
Atte.
Ricardo G. Zúñiga Bauer
Analista programador
Sitio web: http://ceaerrepe.com.ar
User Linux: #455331
Si te miras los logs lo sabrás....
--
Atte.
Ricardo G. Zúñiga Bauer
Analista programador
Sitio web: http://ceaerrepe.com.ar
User Linux: #455331