UAS driver
Hallo,
mit dmesg -c erhalte ich nach dem anschließen einer USB-3 Seagate folgende
Ausgabe: "USB controller does not support streams, which are required by the
UAS driver.
[90844.162558] usb 3-1: Please try an other USB controller if you wish to use”
Hier die ganze Ausgabe:
# dmesg -c
[90839.621157] usb 3-1: USB disconnect, device number 5
[90839.622280] sd 7:0:0:0: [sdf] Synchronizing SCSI cache
[90839.622325] sd 7:0:0:0: [sdf] Synchronize Cache(10) failed: Result:
hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
[90844.126003] usb 3-1: new SuperSpeed USB device number 6 using xhci_hcd
[90844.161720] usb 3-1: New USB device found, idVendor=0bc2, idProduct=2322
[90844.161726] usb 3-1: New USB device strings: Mfr=2, Product=3,
SerialNumber=1
[90844.161728] usb 3-1: Product: Expansion
[90844.161730] usb 3-1: Manufacturer: Seagate
[90844.161732] usb 3-1: SerialNumber: NA845X0N
[90844.162554] usb 3-1: USB controller 0000:03:00.0 does not support streams,
which are required by the UAS driver.
[90844.162558] usb 3-1: Please try an other USB controller if you wish to use
UAS.
[90844.162561] usb-storage 3-1:1.0: USB Mass Storage device detected
[90844.162774] scsi host7: usb-storage 3-1:1.0
[90845.171033] scsi 7:0:0:0: Direct-Access Seagate Expansion 9300
PQ: 0 ANSI: 6
[90845.171526] sd 7:0:0:0: Attached scsi generic sg6 type 0
[90845.174244] sd 7:0:0:0: [sdf] Spinning up disk...
[90846.193405] ...ready
[90848.241923] sd 7:0:0:0: [sdf] 3907029167 512-byte logical blocks: (2.00
TB/1.82 TiB)
[90848.481978] sd 7:0:0:0: [sdf] Write Protect is off
[90848.481980] sd 7:0:0:0: [sdf] Mode Sense: 4f 00 00 00
[90848.482941] sd 7:0:0:0: [sdf] Write cache: enabled, read cache: enabled,
doesn't support DPO or FUA
[90848.514000] sdf: sdf1
[90848.515870] sd 7:0:0:0: [sdf] Attached SCSI disk
[90891.645397] EXT4-fs (dm-13): mounted filesystem with ordered data mode.
Opts: (null)
Ignorieren oder muss man was machen?
--
Liebe Grüße
Sigi
Reply to: