Re: USB stick/cfdisk mit Fehlern
Moin Martin!
Am 11.08.2011 19:27, Martin Steigerwald schrub:
> Am Donnerstag, 11. August 2011 schrieb Frank Lassowski:
>> Device Boot Start End Blocks Id System
>> /dev/sda1 1 107 409600 b W95 FAT32
>> Partition 1 has different physical/logical beginnings (non-Linux?):
>> phys=(0, 32, 33) logical=(0, 33, 3)
>
> Das finde ich komisch. Würd ich mal in $SUCHMASCHINE füttern.
>
>> Partition 1 has different physical/logical endings:
>> phys=(51, 30, 43) logical=(106, 101, 58)
>> Partition 1 does not end on cylinder boundary.
>
> Was zeigt fdisk -cl /dev/sda?
>
> Was zeigt sfdisk -d /dev/sda?
~$ sudo fdisk -cl /dev/sda
Disk /dev/sda: 4004 MB, 4004511744 bytes
124 heads, 62 sectors/track, 1017 cylinders
Units = cylinders of 7688 * 512 = 3936256 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk identifier: 0x0009a170
Device Boot Start End Blocks Id System
/dev/sda1 1 107 409600 b W95 FAT32
/dev/sda2 107 241 512000 83 Linux
/dev/sda3 241 1018 2988032 83 Linux
~$ sudo sfdisk -d /dev/sda
# partition table of /dev/sda
unit: sectors
/dev/sda1 : start= 2048, size= 819200, Id= b
/dev/sda2 : start= 821248, size= 1024000, Id=83
/dev/sda3 : start= 1845248, size= 5976064, Id=83
/dev/sda4 : start= 0, size= 0, Id= 0
Sieht doch alles gut aus.
> Und gib vielleicht mal Auszug von dmesg / syslog, wenn Du den Stick
> einsteckst.
[ 8.907373] scsi 0:0:0:0: Direct-Access SanDisk Cruzer Blade
1.01 PQ: 0 ANSI: 2
[ 8.950066] sd 0:0:0:0: [sda] 7821312 512-byte logical blocks: (4.00
GB/3.72 GiB)
[ 8.959579] sd 0:0:0:0: [sda] Write Protect is off
[ 8.964402] sd 0:0:0:0: [sda] Mode Sense: 03 00 00 00
[ 8.964411] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 8.978553] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 8.984684] sda: sda1 sda2 sda3
[ 8.993054] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 8.999213] sd 0:0:0:0: [sda] Attached SCSI removable disk
alles ganz normal, wie immer.
hm.
Frank
Reply to: