Dirk Salva wrote:
Siehe:On Wed, Dec 10, 2008 at 10:10:53AM +0100, Florian Brandner wrote:Ja, auf meinem Testrechner funktioniert das mit hdparm -y -Y-Y würde reichen, -y ist standby und -Y sleep. In beiden Fällen wird die Festplatte bei einem Zugriff wieder aufwachen und hochfahren, bei -Y dauert es aber wohl länger. Ist etwas her das ich das zuletzt gemacht habe.Ach, das geht auch mit hdparm? Ich hab dafür noch noflushd in Aktion. Wie kann ich denn bei hdparm eine Zeit angeben, nach der das vonstatten gehen soll?!? man hdparm Hier ein Auszug: -S Set the standby (spindown) timeout for the drive. This value is used by the drive to determine how long to wait (with no disk activity) before turning off the spindle motor to save power. Under such circumstances, the drive may take as long as 30 sec- onds to respond to a subsequent disk access, though most drives are much quicker. The encoding of the timeout value is somewhat peculiar. A value of zero means "timeouts are disabled": the device will not automatically enter standby mode. Values from 1 to 240 specify multiples of 5 seconds, yielding timeouts from 5 seconds to 20 minutes. Values from 241 to 251 specify from 1 to 11 units of 30 minutes, yielding timeouts from 30 minutes to 5.5 hours. A value of 252 signifies a timeout of 21 minutes. A value of 253 sets a vendor-defined timeout period between 8 and 12 hours, and the value 254 is reserved. 255 is interpreted as 21 minutes plus 15 seconds. Note that some older drives may have very different interpretations of these values. Gruß Jochenciao, Dirk dd8pz@imail.de |