[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: Etch: Netzwerk nicht konfigurierbar



On Fri, Jan 04, 2008 at 08:06:01PM +0100, Thomas Halinka wrote:
> Am Freitag, den 04.01.2008, 18:15 +0100 schrieb Thorsten Haude:
> > * Klaus Zerwes wrote (2008-01-04 12:43):
> > >dmesg | grep eth
> > 
> > Nach dem Booten:
> > eth0: RealTek RTL8139 at 0x8000, 00:e0:00:ae:8a:18, IRQ 9
> > eth0:  Identified 8139 chip type 'RTL-8139C'

RealTek 8139 ist doch kein WLAN?

> > eth0: Hardware identity 8013:0000:0001:0000
> > eth0: Station identity  001f:0001:0001:0004
> > eth0: Firmware determined as Intersil 1.4.1
> > eth0: Ad-hoc demo mode supported
> > eth0: IEEE standard IBSS ad-hoc mode supported
> > eth0: WEP supported, 104-bit key
> > eth0: MAC address 00:E0:00:87:8E:AE
> > eth0: Station name "Prism  I"
> > eth0: ready
> > eth0: orinoco_pci at 0000:00:12.0
> 
> Das ist wlan

Tja, eth0 ist wohl beides, LAN und WLAN!?? So etwas habe ich noch nicht
gesehen. Tippe auf einen Treiberfehler. Eventuell ist ja nur die Ausgabe
(eth0 statt eth?) betroffen und fehlerhaft?
 
> > eth1: link up, 100Mbps, full-duplex, lpa 0x45E1
> 
> und das LAN

Jens


Reply to: