Re: Framebuffermodus mit Kernel bf2.4 - nur 80x30 ?
Am Sam, 2003-07-26 um 16.21 schrieb Ruediger Noack:
> Moin
>
> Ich habe auf einem Laptop (LCD-Auflösung 1024x768) woody mit Kernel bf2.4
> neu installiert. Dabei wird automatisch der Framebuffer in 80x30 benutzt.
> Damit ist das Display nur sehr spärlich (große Ränder an allen Seiten)
> ausgenutzt.
>
> Versuche ich über lilo (vga=ask) einen anderen Modus einzustellen, wirkt
Ich verwende bei mir die Einstellung vga=792 was der 1024er Auflösung entspricht.
Genauere Informationen gibt es in
/usr/src/linux/Documentation/fb/vesafb.txt:
-----------------------------------------------------------------------------
How to use it?
==============
Switching modes is done using the vga=... boot parameter. Read
Documentation/svga.txt for details.
You should compile in both vgacon (for text mode) and vesafb (for
graphics mode). Which of them takes over the console depends on
whenever the specified mode is text or graphics.
The graphic modes are NOT in the list which you get if you boot with
vga=ask and hit return. The mode you wish to use is derived from the
VESA mode number. Here are those VESA mode numbers:
| 640x480 800x600 1024x768 1280x1024
----+-------------------------------------
256 | 0x101 0x103 0x105 0x107
32k | 0x110 0x113 0x116 0x119
64k | 0x111 0x114 0x117 0x11A
16M | 0x112 0x115 0x118 0x11B
Linux_kernel_mode_number = VESA_mode_number + 0x200
So the table for the Kernel mode numbers are:
| 640x480 800x600 1024x768 1280x1024
----+-------------------------------------
256 | 0x301 0x303 0x305 0x307
32k | 0x310 0x313 0x316 0x319
64k | 0x311 0x314 0x317 0x31A
16M | 0x312 0x315 0x318 0x31B
To enable one of those modes you have to specify "vga=ask" in the
lilo.conf file and rerun LILO. Then you can type in the desired
mode at the "vga=ask" prompt. For example if you like to use
1024x768x256 colors you have to say "305" at this prompt.
If this does not work, this might be because your BIOS does not support
linear framebuffers or because it does not support this mode at all.
Even if your board does, it might be the BIOS which does not. VESA BIOS
Extensions v2.0 are required, 1.2 is NOT sufficient. You will get a
"bad mode number" message if something goes wrong.
1. Note: LILO cannot handle hex, for booting directly with
"vga=mode-number" you have to transform the numbers to decimal.
2. Note: Some newer versions of LILO appear to work with those hex values,
if you set the 0x in front of the numbers.
-----------------------------------------------------------------------------
chm
Reply to: