modem verbindung bleibt nicht bestehen
Moin liebe Debianer
Ich habe bin neu bei Debian-Linux
und habe nun folgendes Problem:
Wenn ich versuche irgendeinen Provider mit Modem anzuwählen,
wird die Verbindung gleich wieder gekappt.
Ich habe ein Dell Laptop mit Lucent-Winmodem.
Ich habe alles ausprobiert, was im Netz zu finden war
(Insbes. Jacques Goldbergs "Linmodem Post-Install Problems"
und das "Linmodem HOWTO" von Sean Walbran und Marvin Stodolsky.)
und bin jetzt ziemlich ratlos.
Anbei versch. Log-Daten, für jemanden mit Ahnung ...
Die Installation ist wegen der Notebookhardware etwas
mühselig aber macht Debian einen schönen Eindruck.
Vielen Dank im voraus!
Bye
Ulf Martin
ulf.martin@gmx.net
## Alles wie im Debian-Anwenderhandbuch ###
Programm: pon
Einstellungen mit: pppconfig
"PAP" (unter Windows 2000 funktioniert's.)
Modeminitialisierung mit: ATM0
###
/var/log/messages
Mar 6 10:51:26 umobile pppd[509]: pppd 2.4.1 started by root, uid 0
Mar 6 10:51:27 umobile chat[510]: abort on (BUSY)
Mar 6 10:51:27 umobile chat[510]: abort on (NO CARRIER)
Mar 6 10:51:27 umobile chat[510]: abort on (VOICE)
Mar 6 10:51:27 umobile chat[510]: abort on (NO DIALTONE)
Mar 6 10:51:27 umobile chat[510]: abort on (NO DIAL TONE)
Mar 6 10:51:27 umobile chat[510]: abort on (NO ANSWER)
Mar 6 10:51:27 umobile chat[510]: abort on (DELAYED)
Mar 6 10:51:27 umobile chat[510]: send (ATM0^M)
Mar 6 10:51:27 umobile chat[510]: expect (OK)
Mar 6 10:51:27 umobile chat[510]: ATM0^M^M
Mar 6 10:51:27 umobile chat[510]: OK
Mar 6 10:51:27 umobile chat[510]: -- got it
Mar 6 10:51:27 umobile chat[510]: send (ATDT019389687^M)
Mar 6 10:51:28 umobile pppd[509]: Serial connection established.
Mar 6 10:51:28 umobile pppd[509]: Using interface ppp0
Mar 6 10:51:28 umobile pppd[509]: Connect: ppp0 <--> /dev/modem
Mar 6 10:51:59 umobile pppd[509]: LCP: timeout sending Config-Requests
Mar 6 10:51:59 umobile pppd[509]: Connection terminated.
Mar 6 10:51:59 umobile pppd[509]: Receive serial link is not 8-bit
clean:
Mar 6 10:51:59 umobile pppd[509]: Problem: all had bit 7 set to 0
Mar 6 10:52:00 umobile pppd[509]: Exit.
### Die Module ###
/proc/modules
lt_serial 21312 0 (autoclean)
lt_modem 314432 0 (autoclean) [lt_serial]
ppp_async 6176 0
ppp_generic 17384 0 [ppp_async]
slhc 4352 0 [ppp_generic]
NVdriver 820064 16 (autoclean)
tap0 2464 1 (autoclean)
eepro100 16944 1 (autoclean)
nls_iso8859-1 2848 1 (autoclean)
nls_cp437 4384 1 (autoclean)
serial 44832 0 (autoclean)
isa-pnp 27784 0 (autoclean) [serial]
vfat 9276 1
fat 29112 0 [vfat]
ide-scsi 7360 0
sg 28068 0 (unused)
scsi_mod 85224 2 [ide-scsi sg]
rtc 5528 0 (autoclean)
###
lspci -v
00:00.0 Host bridge: Intel Corp. 82815 815 Chipset Host Bridge and
Memory Controller Hub (rev 02)
Flags: bus master, fast devsel, latency 0
Memory at e8000000 (32-bit, prefetchable) [size=64M]
Capabilities: [88] #09 [f104]
Capabilities: [a0] AGP version 2.0
00:01.0 PCI bridge: Intel Corp.: Unknown device 1131 (rev 02) (prog-if
00 [Normal decode])
Flags: bus master, 66Mhz, fast devsel, latency 32
Bus: primary=00, secondary=01, subordinate=01, sec-latency=32
I/O behind bridge: 0000c000-0000cfff
Memory behind bridge: fc000000-fdffffff
Prefetchable memory behind bridge: e0000000-e7ffffff
00:1e.0 PCI bridge: Intel Corp. 82820 820 (Camino 2) Chipset PCI (-M)
(rev 02) (prog-if 00 [Normal decode])
Flags: bus master, fast devsel, latency 0
Bus: primary=00, secondary=02, subordinate=10, sec-latency=32
I/O behind bridge: 0000d000-0000ffff
Memory behind bridge: f2000000-fbffffff
00:1f.0 ISA bridge: Intel Corp. 82820 820 (Camino 2) Chipset ISA Bridge
(ICH2-M) (rev 02)
Flags: bus master, medium devsel, latency 0
00:1f.1 IDE interface: Intel Corp. 82820 820 (Camino 2) Chipset IDE
U100 (-M) (rev 02) (prog-if 80 [Master])
Subsystem: Intel Corp.: Unknown device 4541
Flags: bus master, medium devsel, latency 0
I/O ports at bfa0 [size=16]
00:1f.2 USB Controller: Intel Corp. 82820 820 (Camino 2) Chipset USB
(Hub A) (rev 02) (prog-if 00 [UHCI])
Subsystem: Intel Corp.: Unknown device 4541
Flags: bus master, medium devsel, latency 0, IRQ 10
I/O ports at bce0 [size=32]
01:00.0 VGA compatible controller: nVidia Corporation GeForce2 Go (rev
b2) (prog-if 00 [VGA])
Subsystem: Dell Computer Corporation: Unknown device 00a4
Flags: bus master, VGA palette snoop, 66Mhz, medium devsel, latency
248, IRQ 11
Memory at fc000000 (32-bit, non-prefetchable) [size=16M]
Memory at e0000000 (32-bit, prefetchable) [size=128M]
Expansion ROM at <unassigned> [disabled] [size=64K]
Capabilities: [60] Power Management version 2
Capabilities: [44] AGP version 2.0
02:03.0 Multimedia audio controller: ESS Technology ES1983S Maestro-3i
PCI Audio Accelerator (rev 10)
Subsystem: Dell Computer Corporation: Unknown device 00a4
Flags: bus master, medium devsel, latency 32, IRQ 5
I/O ports at dc00 [size=256]
Memory at f6ffe000 (32-bit, non-prefetchable) [size=8K]
Capabilities: [c0] Power Management version 2
02:06.0 PCI bridge: Action Tec Electronics Inc: Unknown device 0100
(rev 11) (prog-if 00 [Normal decode])
Flags: bus master, medium devsel, latency 32
Bus: primary=02, secondary=08, subordinate=08, sec-latency=32
I/O behind bridge: 0000e000-0000efff
Memory behind bridge: f8000000-f9ffffff
Capabilities: [80] Power Management version 2
Capabilities: [90] #06 [0000]
02:0f.0 CardBus bridge: Texas Instruments PCI4451 PC card Cardbus
Controller
Subsystem: Dell Computer Corporation: Unknown device 00a4
Flags: bus master, medium devsel, latency 32, IRQ 10
Memory at f2000000 (32-bit, non-prefetchable) [size=4K]
Bus: primary=02, secondary=09, subordinate=0c, sec-latency=32
I/O window 0: 00000000-00000003
I/O window 1: 00000000-00000003
16-bit legacy interface ports at 0001
02:0f.1 CardBus bridge: Texas Instruments PCI4451 PC card Cardbus
Controller
Subsystem: Dell Computer Corporation: Unknown device 00a4
Flags: bus master, medium devsel, latency 32, IRQ 10
Memory at f2001000 (32-bit, non-prefetchable) [size=4K]
Bus: primary=02, secondary=0d, subordinate=10, sec-latency=32
I/O window 0: 00000000-00000003
I/O window 1: 00000000-00000003
16-bit legacy interface ports at 0001
02:0f.2 FireWire (IEEE 1394): Texas Instruments: Unknown device 8027
(prog-if 10 [OHCI])
Subsystem: Dell Computer Corporation: Unknown device 00a4
Flags: bus master, medium devsel, latency 32, IRQ 10
Memory at f6ffd800 (32-bit, non-prefetchable) [size=2K]
Memory at f6ff8000 (32-bit, non-prefetchable) [size=16K]
Capabilities: [44] Power Management version 2
08:04.0 Ethernet controller: Intel Corp. 82557 [Ethernet Pro 100] (rev
08)
Subsystem: Action Tec Electronics Inc: Unknown device 1100
Flags: bus master, medium devsel, latency 32, IRQ 10
Memory at f8fff000 (32-bit, non-prefetchable) [size=4K]
I/O ports at ecc0 [size=64]
Memory at f8e00000 (32-bit, non-prefetchable) [size=1M]
Expansion ROM at f9000000 [disabled] [size=1M]
Capabilities: [dc] Power Management version 2
08:08.0 Communication controller: Lucent Microelectronics WinModem 56k
(rev 01)
Subsystem: Action Tec Electronics Inc: Unknown device 2400
Flags: bus master, medium devsel, latency 0, IRQ 10
Memory at f8ffec00 (32-bit, non-prefetchable) [size=256]
I/O ports at ecb8 [size=8]
I/O ports at e800 [size=256]
Capabilities: [f8] Power Management version 2
/proc/ioports :
0000-001f : dma1
0020-003f : pic1
0040-005f : timer
0060-006f : keyboard
0070-007f : rtc
0080-008f : dma page reg
00a0-00bf : pic2
00c0-00df : dma2
00f0-00ff : fpu
01f0-01f7 : ide0
03c0-03df : vga+
03f6-03f6 : ide0
03f8-03ff : serial(set)
0cf8-0cff : PCI conf1
bce0-bcff : Intel Corp. 82820 820 (Camino 2) Chipset USB (Hub A)
bfa0-bfaf : Intel Corp. 82820 820 (Camino 2) Chipset IDE U100 (-M)
bfa0-bfa7 : ide0
c000-cfff : PCI Bus #01
d000-ffff : PCI Bus #02
dc00-dcff : ESS Technology ES1983S Maestro-3i PCI Audio Accelerator
e000-efff : PCI Bus #08
e800-e8ff : Lucent Microelectronics WinModem 56k
e800-e8ff : ltserial
ecb8-ecbf : Lucent Microelectronics WinModem 56k
ecc0-ecff : Intel Corp. 82557 [Ethernet Pro 100]
ecc0-ecff : eepro100
Reply to: