Re: configuració tageta TV.
A Dijous 11 Maig 2006 01:36, Joan Alfonso va escriure:
> bttv0: using: *** UNKNOWN/GENERIC *** [card=0,autodetected]
Hauries d'intentar passar al mòdul bbtv0 el model de tarja que tens. Trobaras
la llista a /usr/share/doc/linux-doc-2.6.16/Documentation/video4linux
En el meu cas, ho conté el paquet linux-doc-2.6.16.
Per cert, estic provant una tarja.
----------------------
0000:05:02.0 Multimedia controller: Philips Semiconductors SAA7133 Video
Broadcast Decoder (rev d0)
Subsystem: Unknown device 4e42:3306
Flags: bus master, medium devsel, latency 64, IRQ 50
Memory at fb7fe800 (32-bit, non-prefetchable) [size=2K]
Capabilities: <available only to root>
----------------------
Una Zaapa.net d'aquestes que venen al Carrefour :))) És híbrida (digital,
analògica, ràdio) i pel que he vist a http://www.bttv-gallery.de/ sembla
clavada a les FlyDVB-T.
Segons la llista de targes hauria de ser una 55, però no carrega
el /dev/radio. Sí ho fa amb el model més nou de FlyDVB-T, la 84. Però dóna
un altre error: «dsp access error» del que no trobo informació.
Alguna idea? Si no va, la torno.
----------------------
# modprobe saa7134 card=84 audio_debug=1
syslog:
May 10 21:33:55 itaca kernel: saa7130/34: v4l2 driver version 0.2.14 loaded
May 10 21:33:55 itaca kernel: ACPI: PCI Interrupt 0000:05:02.0[A] -> GSI 18
(level, low) -> IRQ 50
May 10 21:33:55 itaca kernel: saa7133[0]: found at 0000:05:02.0, rev: 208,
irq: 50, latency: 64, mmio: 0xfb7fe800
May 10 21:33:55 itaca kernel: saa7133[0]: subsystem: 4e42:3306, board:
LifeView FlyDVB Trio [card=84,insmod option]
May 10 21:33:55 itaca kernel: saa7133[0]: board init: gpio is 10000
May 10 21:33:55 itaca kernel: tuner 1-004b: chip found @ 0x96 (saa7133[0])
May 10 21:33:55 itaca kernel: tuner 1-004b: setting tuner address to 61
May 10 21:33:55 itaca kernel: tuner 1-004b: tuner: type set to tda8290+75a
May 10 21:33:56 itaca kernel: saa7133[0]: i2c eeprom 00: 42 4e 06 33 54 20 1c
00 43 43 a9 1c 55 d2 b2 92
May 10 21:33:56 itaca kernel: saa7133[0]: i2c eeprom 10: 00 00 62 08 ff 20 ff
ff ff ff ff ff ff ff ff ff
May 10 21:33:56 itaca kernel: saa7133[0]: i2c eeprom 20: 01 40 01 03 03 01 01
03 08 ff 01 ed ff ff ff ff
May 10 21:33:56 itaca kernel: saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff
ff ff ff ff ff ff ff ff ff
May 10 21:33:56 itaca kernel: saa7133[0]: i2c eeprom 40: ff 21 00 c2 96 10 05
01 01 16 32 15 ff ff ff ff
May 10 21:33:56 itaca kernel: saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff
ff ff ff ff ff ff ff ff ff
May 10 21:33:56 itaca kernel: saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff
ff ff ff ff ff ff ff ff ff
May 10 21:33:56 itaca kernel: saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff
ff ff ff ff ff ff ff ff ff
May 10 21:33:57 itaca kernel: saa7133[0]: dsp access error
May 10 21:33:57 itaca last message repeated 5 times
May 10 21:33:57 itaca kernel: saa7133[0]/audio: tvaudio thread scan start [1]
May 10 21:33:57 itaca kernel: saa7133[0]/audio: PAL scan
May 10 21:33:57 itaca kernel: saa7133[0]/audio: scanning: B/G D/K I
May 10 21:33:57 itaca kernel: saa7133[0]: dsp access error
May 10 21:33:57 itaca last message repeated 3 times
May 10 21:33:57 itaca kernel: saa7133[0]: registered device video0 [v4l2]
May 10 21:33:57 itaca kernel: saa7133[0]: registered device vbi0
May 10 21:33:57 itaca kernel: saa7133[0]: registered device radio0
May 10 21:33:57 itaca kernel: saa7133[0]: dsp access error
May 10 21:33:57 itaca kernel: saa7133[0]: dsp access error
May 10 21:34:00 itaca kernel: saa7133[0]/audio: tvaudio thread status:
0x100000 [no standard detected]
May 10 21:34:00 itaca kernel: saa7133[0]/audio: detailed status: #############
init done
----------------------
--
Benjamí
http://blog.bitassa.cat
.
Reply to: