lvm setup during sarge installation
Hi!
I was trying to install a lab machine using Sarge with LVM. I used the
network install CD with the last release.
Using linux26 as boot parameter I've proceed normally during install. I
first created a small partition with 300Mb to be my / with reiserfs and
initialization flag enabled. There was 29Gb free on disk.
Then I've selected from menu to config LVM. I said yes to confirm my
changes and a red screen appeared saying that lvm-mod was not loaded. I
went to a shell and did a insmod lvm-mod but this module didn't not
exists.
There is any way to make it works?
Thanks for help!
Reply to: