Re: How to boot SUN T5220?
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA256
On 05/10/2011 11:38 AM, Flamarion Jorge wrote:
> On 05/09/2011 05:42 PM, Jurij Smakov wrote:
>> On Mon, May 09, 2011 at 05:19:03PM -0300, Flamarion Jorge wrote:
>> [...]
>>>> First thanks for trying to help me.
>>>>
>>>> My problem is: I can not load the silo from the "ok prompt"
>>>>
>>>> When i install Debian, using guided partitioning of Debian Installer,
>>>> and the installation finished successfully, after the first reboot I get
>>>> the following message:
>>>>
>>>> {0} ok boot disk
>>>> Boot device: /pci@0/pci@0/pci@2/scsi@0/disk@0 File and args:
>>>> Bad magic number in disk label
>>>> Can't open disk label package
>>>> ERROR: boot-read fail
>>>>
>>>>
>>>> Can't open boot device
>>>>
>>>>> Try 'boot disk1'.
>>>
>>> Hi Jurij,
>>>
>>> {0} ok boot disk1
>>> Boot device: /pci@0/pci@0/pci@2/scsi@0/disk@1 File and args:
>>> ERROR: boot-read fail
>>>
>>>
>>> Can't open boot device
>>>
>>> {0} ok
>
>> Ok, it must be something else then. Usually, when there is a problem
>> with disklabel, a standard recommendation is to zero out the first few
>> megabytes of the disks and then write a brand new disklabel to make
>> sure that everything is ok (warning: this will irrecoverably destroy
>> all data on the disks!). It goes something like this:
>
>> 1. Boot the installer as usual.
>> 2. Proceed to the point where the disks are detected and partitioner
>> is started.
>> 3. Press 'Back' button until you get to installer menu.
>> 4. Choose an option to start a shell.
>> 5. Run the following commands:
>
>> dd if=/dev/zero of=/dev/sda bs=1M count=100
>> dd if=/dev/zero of=/dev/sdb bs=1M count=100
>> sync
>
>> 6. Exit the shell and restart the partitioner.
>> 7. Choose the guided partitioning, it should write a new disklabel and
>> create the partitions.
>> 8. Continue installation as usual.
>
>> Best regards,
>> --
>> Jurij Smakov jurij@wooyd.org
>> Key: http://www.wooyd.org/pgpkey/ KeyID: C99E03CC
>
>
>
>
> Jurij,
>
> I followed your tip, but the result was the same.
>
> Attached below the install script to follow, there may be something I
> did wrong and not noticed.
>
> If there is anything I can do, I would be grateful in hearing from you.
>
> []'s
>
Hi again,
This is a valid model of partitioning on SPARC?
~ # fdisk /dev/sda
Command (m for help): p
Disk /dev/sda (Sun disk label): 255 heads, 63 sectors, 17840 cylinders
Units = cylinders of 16065 * 512 bytes
Device Flag Start End Blocks Id System
/dev/sda1 0 12 96390 1 Boot
/dev/sda2 12 17080 137098710 83 Linux native
/dev/sda3 0 17840 143299800 5 Whole disk
/dev/sda4 17080 17840 6104700 82 Linux swap
Tks,
- --
Flamarion Jorge
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.11 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/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=zzfK
-----END PGP SIGNATURE-----
Reply to: