Installing etch on netra T1 200 => no disk found

[Laurent GUERBY <laurent@guerby.net>]

Hi,

I'm trying to install etch (since lenny installer freezes during network
detection) on my netra T1 200. My problem is that no disk are detected
whereas I added two disks to the netra.

Any idea on what to try? I did a loop modprobe on all drivers in scsi
but this didn't make a difference. May be there's something to do in the
firmware?

~ # lspci -nn
00:00.0 Host bridge [0600]: Sun Microsystems Computer Corp. Ultra IIe [108e:a001]
00:01.0 PCI bridge [0604]: Sun Microsystems Computer Corp. Simba Advanced PCI Bridge [108e:5000] (rev 13)

00:01.1 PCI bridge [0604]: Sun Microsystems Computer Corp. Simba Advanced PCI Bridge [108e:5000] (rev 13)

01:03.0 Non-VGA unclassified device [0000]: ALi Corporation M7101 Power Management Controller [PMU] [10b9:7101]
01:05.1 Ethernet controller [0200]: Sun Microsystems Computer Corp. RIO GEM [108e:1101] (rev 01)

01:05.3 USB Controller [0c03]: Sun Microsystems Computer Corp. RIO USB [108e:1103] (rev 01)
01:07.0 ISA bridge [0601]: ALi Corporation M1533/M1535 PCI to ISA Bridge [Aladdin IV/V/V+] [10b9:1533]
01:0c.0 Bridge [0680]: Sun Microsystems Computer Corp. RIO EBUS [108e:1100] (rev 01)
01:0c.1 Ethernet controller [0200]: Sun Microsystems Computer Corp. RIO GEM [108e:1101] (rev 01)
01:0c.3 USB Controller [0c03]: Sun Microsystems Computer Corp. RIO USB [108e:1103] (rev 01)
01:0d.0 IDE interface [0101]: ALi Corporation M5229 IDE [10b9:5229] (rev c3)
02:08.0 SCSI storage controller [0100]: LSI Logic / Symbios Logic 53C896/897 [1000:000b] (rev 07)
02:08.1 SCSI storage controller [0100]: LSI Logic / Symbios Logic 53C896/897 [1000:000b] (rev 07)

Thanks in advance,

Laurent