Hello On 11/04/2025 07:10, John Paul Adrian Glaubitz wrote:
On the PPC64, I tested the installation on my PowerMac G5 and for the first time, it went well! Then, I have a blocking problem though, when Linux boots. I found that it was related to the graphics card. In the X log, I get: (II) LoadModule: "nouveau" (WW) Warning, couldn't open module nouveau (EE) Failed to load module "nouveau" (module does not exist, 0) And at the end: (II) modesetting: Driver for Modesetting Kernel Drivers: kms (II) FBDEV: driver for framebuffer: fbdev (II) modeset(0): using drv /dev/dri/card0 (WW) Falling back to old probe method for fbdev (II) Loading sub module"fbdevhw" The fact is that I have no display.
Raphaël: I tried adding nouveau.noaccel=1 and it worked. However, I think it is not the best.
Can you verify that the package xserver-xorg-video-nouveau is actually installed?
I tried and it was not installed. After I installed it, it worked!I have to say that previously, I followed another advice that was to install firmware-misc-nonfree, I don't know if that had an impact at the end (just with this one, there was no benefit).
Note: I chose Mate and after some time, I had the login screen and after the login, I've lost mouse clicks, they are no effect. I can't have any action with it on the desktop.
Mathias