Re: Partition check
Em Qua 01 Jun 2005 09:15, Martin Habets escreveu:
> On Tue, May 31, 2005 at 09:12:47PM -0300, Gunther Furtado wrote:
> > Hello,
> >
> > This is the reading I get whe I boot the 2.4.25-behn kernel.
> >
> > Parition check:
> > hda: [mac] hda1 hda2 hda3 hda4 hda5 hda6 hda7 hda8 hda9 hda10 hda11 hda12
> >
> > And this is when i boot a kernel I compiled from linux-2.4.26 sources.
> >
> > Partition check:
> > /dev/ide/host0/bus0/target0/lun0: [mac] p1 p2 p3 p4 p5 p6 p7 p8 p9 p10
> > p11 p12
> >
> > Can anyone tell what did I switched off from Behn's kernel configuration?
>
> The benh kernel accesses the hard disk as an IDE device. Your later kernel
> sees it as a SCSI device. First check if you have a boot parameter like
> "hda=scsi" and if so, remove it.
>
There were not "hda=scsi" in may yaboot.conf file. But, if my kernel accesses
the HD as SCSI, why the line after partition check:
/dev/ide/host0/bus0/target0/lun0: [mac] p1 p2 p3 p4 p5 p6 p7 p8 p9 p10 p11 p12
reads /dev/ide and not /dev/scsi ?
Gunther Furtado
------------------
Curitiba - PR - Brasil
Reply to: