Re: Huawei E3372: still a problem
1)
I stopped the computer, removed the Huawei device from the computer,
started again and installed another usb device there in the same slot.
2)
Started the computer again.
And Huawei stopped working.
3)
And when giving again the command
# usb_modeswitch -J -v 0x12d1 -p 0x157d
It started working.
4)
What should I do to get it permanently working?
-hv
--------------------------------------------
On Thu, 2/26/15, Hannu Virtanen <hannu_markus_virtanen@yahoo.com> wrote:
Subject: Re: Huawei E3372: Success (!)
To: "Bjørn Mork" <bjorn@mork.no>
Cc: "Petr Kubánek" <petr@kubanek.net>, debian-laptop@lists.debian.org
Date: Thursday, February 26, 2015, 5:40 PM
giving:
--- ---
#
usb_modeswitch -J -v 0x12d1 -p 0x157d
Look
for default devices ...
product ID matched
Found devices in default mode (1)
Access device 006 on bus 007
Current configuration number is 1
Use interface number 0
Use
endpoints 0x01 (out) and 0x81 (in)
USB description data (for identification)
-------------------------
Manufacturer: HUAWEI_MOBILE
Product: HUAWEI_MOBILE
Serial No.: 0123456789ABCDEF
-------------------------
Using
standard Huawei switching message
Looking
for active driver ...
OK, driver
detached
Set up interface 0
Use endpoint 0x01 for message sending ...
Trying to send message 1 to endpoint 0x01
...
OK, message successfully sent
Reset response endpoint 0x81
--- ---
And now it is working(!)
Actually I don't know if everything started
working only because of with that - J option,
because I tried it already once earlier. I have
isntalled one firmware from Huawei too during this
work...
-hv
Reply to: