D-Link DWL 650
Hi,
I've got a D-Link DWL 650 wlan card and a problem with it... When I insert the
card I dmsg shows the following messages:
init_module: prism2_cs.o: 0.1.15 Loaded
init_module: dev_info is: prism2_cs
prism2_cs: index 0x01: Vcc 3.3, irq 11, io 0x0100-0x013f
ident: nic h/w: id=0x800c 1.0.0
ident: pri f/w: id=0x15 1.0.7
ident: sta f/w: id=0x1f 1.3.5
MFI:SUP:role=0x00:id=0x01:var=0x01:b/t=1/1
CFI:SUP:role=0x00:id=0x02:var=0x02:b/t=1/1
PRI:SUP:role=0x00:id=0x03:var=0x01:b/t=4/4
STA:SUP:role=0x00:id=0x04:var=0x01:b/t=1/9
PRI-CFI:ACT:role=0x01:id=0x02:var=0x02:b/t=1/1
STA-CFI:ACT:role=0x01:id=0x02:var=0x02:b/t=1/1
STA-MFI:ACT:role=0x01:id=0x01:var=0x01:b/t=1/1
Prism2 card SN: 99SA01000000
Ifconfig shows the wlan device wlan0:
wlan0 Link encap:Ethernet HWaddr 00:05:5D:EE:F5:AE
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
iwconfig shows:
wlan0 IEEE 802.11-b ESSID:"non-spec"
Mode:Managed Frequency:2.442GHz Access Point: 44:44:44:44:44:44
Bit Rate:200kb/s
Link Quality:0/100 Signal level:81/100 Noise level:27/100
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
And I don't get any device like a eth1, which I could configure for Internet
access...
Because of my good experience with wlan_ng on my Sharp Zaurus I wanted to use
it on my notebook (HP omnibook xt1000), too...
I hope You have some good ideas :-)
greetz
Max
--
-----BEGIN GEEK CODE BLOCK-----
Version: 3.12
GIT(S) dx s: a--- C++ UL++++ P+ L+++ E--- W+++ N+ o-- K- w--
O-- M- V- PS+ PE++ Y PGP++ t- 5-- X- R- tv b+(++) DI++ D+
G e* h! r y?
------END GEEK CODE BLOCK------
GnuPG key available on http://www.linuxforall.de
Think about TCPA
Don't let entertainment industry cut Your rights!
FAQ:
English: http://www.cl.cam.ac.uk/~rja14/tcpa-faq.html
German: http://moon.hipjoint.de/tcpa-palladium-faq-de.html
Reply to: