Re: [debian-knoppix] knoppix don't find my graphiccard
*sigh* Insufficient information!!!
You still did not tell me which
knoppix xmodule=
line worked for your card. See below.
Without this, I can't change anything!
Regards
-Klaus Knopper
On Sat, Dec 07, 2002 at 12:24:14PM +0100, Dirk Kamp wrote:
> following
> > > chips use :
> > >
> > > Graphicprozessor : 3Dlabs GLINT MX
> > > 3D Prozessor : 3Dlabs GLINT Delta
> > > VGA : S3 Virge
> >
> > Unsufficient information. Please send me the PCI numbers of this card as
> > shown with lspci; lspci -n as stated in the FAQ.
>
> The Gloria 3D graphiccards are openGL cards. There are older but good. At
> startup the card use the S3 chip as vga and then the OS switch to the other
> graphicprozessors (as is GLINT MX and GLINT Delta) . Red hat 6 ident this
> card and use it. Knoppix can´t find it and start only in textmode, without
> KDE.
>
> The lspci Numbers are (complete list show by lspci) :
>
> 00:00.0 class 0600: 8086:7190 (rev 03)
> 00:01.0 class 0604: 8086:7191 (rev 03)
> 00:04.0 class 0601: 8086:7110 (rev 02)
> 00:04.1 class 0101: 8086:7111 (rev 01)
> 00:04.2 class 0c03: 8086:7112 (rev 01)
> 00:04.3 class 0680: 8086:7113 (rev 02)
> 00:09.0 class 0280: 1244:0a00 (rev 02)
> 00:0a.0 class 0300: 102b:051a (rev 03)
> 00:0b.0 class 0200: 1106:3065 (rev 42)
>
> > Try booting in framebuffer mode with
> > fb1024x768
> > as mentioned in the F2 help. You could also try
> > knoppix xmodule=s3virge
> > or
> > knoppix xmodule=s3
> > if your card does not support framebuffer mode (if you get a penguin in
> > the left upper corner when Knoppix boots in textmode, your graphics card
> > DOES support linear framebuffer mode).
>
> I can´t see the penguin at startup. I become the error befor the system show
> the startup protocol.
>
> greetings
>
> Dirk Kamp
_______________________________________________
debian-knoppix mailing list
debian-knoppix@linuxtag.org
http://mailman.linuxtag.org/mailman/listinfo/debian-knoppix
Reply to: