[ 7.410233] yenta_cardbus 0000:0a:09.0: TI: mfunc 0x01321b22,
devctl 0x66
[ 7.483675] iwl3945: Intel(R) PRO/Wireless 3945ABG/BG Network
Connection driver for Linux, 1.2.26ks
[ 7.483679] iwl3945: Copyright(c) 2003-2009 Intel Corporation
[ 7.483754] iwl3945 0000:02:00.0: enabling device (0000 -> 0002)
[ 7.483767] iwl3945 0000:02:00.0: PCI INT A -> GSI 16 (level, low)
-> IRQ 16
[ 7.483788] iwl3945 0000:02:00.0: setting latency timer to 64
[ 7.523764] iwl3945 0000:02:00.0: Tunable channels: 13 802.11bg, 23
802.11a channels
[ 7.523768] iwl3945 0000:02:00.0: Detected Intel Wireless WiFi Link
3945ABG
[ 7.523939] iwl3945 0000:02:00.0: irq 29 for MSI/MSI-X
[ 7.646219] yenta_cardbus 0000:0a:09.0: ISA IRQ mask 0x0038, PCI irq 20
[ 7.646225] yenta_cardbus 0000:0a:09.0: Socket status: 30000006
[ 7.646230] pci_bus 0000:0a: Raising subordinate bus# of parent bus
(#0a) from #0b to #0e
[ 7.646240] yenta_cardbus 0000:0a:09.0: pcmcia: parent PCI bridge
I/O window: 0x3000 - 0x3fff
[ 7.646244] pcmcia_socket pcmcia_socket0: cs: IO port probe
0x3000-0x3fff: clean.
[ 7.646516] yenta_cardbus 0000:0a:09.0: pcmcia: parent PCI bridge
Memory window: 0xc8300000 - 0xc83fffff
[ 7.646521] yenta_cardbus 0000:0a:09.0: pcmcia: parent PCI bridge
Memory window: 0xc4000000 - 0xc7ffffff
[ 7.747615] Synaptics Touchpad, model: 1, fw: 6.2, id: 0x12a0b1,
caps: 0xa04713/0x204000
[ 7.791949] input: SynPS/2 Synaptics TouchPad as
/devices/platform/i8042/serio4/input/input7
[ 8.220279] phy0: Selected rate control algorithm 'iwl-3945-rs'
[ 8.288506] HDA Intel 0000:00:1b.0: PCI INT A -> GSI 22 (level,
low) -> IRQ 22
[ 8.288551] HDA Intel 0000:00:1b.0: setting latency timer to 64
[ 8.383329] input: HDA Digital PCBeep as
/devices/pci0000:00/0000:00:1b.0/input/input8
[ 8.453020] pcmcia_socket pcmcia_socket0: cs: IO port probe
0x100-0x3af: clean.
[ 8.455021] pcmcia_socket pcmcia_socket0: cs: IO port probe
0x3e0-0x4ff: excluding 0x4d0-0x4d7
[ 8.455889] pcmcia_socket pcmcia_socket0: cs: IO port probe
0x820-0x8ff: clean.
[ 8.456625] pcmcia_socket pcmcia_socket0: cs: IO port probe
0xc00-0xcf7: clean.
[ 8.457556] pcmcia_socket pcmcia_socket0: cs: IO port probe
0xa00-0xaff: clean.
[ 9.327459] Adding 393520k swap on /dev/hda5. Priority:-1
extents:1 across:393520k
[ 9.715324] EXT3 FS on hda10, internal journal
[ 10.387860] loop: module loaded
[ 11.095078] kjournald starting. Commit interval 5 seconds
[ 11.095451] EXT3 FS on hda11, internal journal
[ 11.095456] EXT3-fs: mounted filesystem with ordered data mode.
[ 12.846642] apm: BIOS not found.
[ 18.720019] Bluetooth: Core ver 2.15
[ 18.720146] NET: Registered protocol family 31
[ 18.720152] Bluetooth: HCI device and connection manager initialized
[ 18.720159] Bluetooth: HCI socket layer initialized
[ 18.751981] Bluetooth: L2CAP ver 2.13
[ 18.751987] Bluetooth: L2CAP socket layer initialized
[ 18.802489] Bluetooth: RFCOMM socket layer initialized
[ 18.802504] Bluetooth: RFCOMM TTY layer initialized
[ 18.802509] Bluetooth: RFCOMM ver 1.11
[ 18.838230] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[ 18.838238] Bluetooth: BNEP filters: protocol multicast
[ 18.877024] Bridge firewalling registered
[ 18.896709] Bluetooth: SCO (Voice Link) ver 0.6
[ 18.896715] Bluetooth: SCO socket layer initialized
[ 19.796049] lp: driver loaded but no devices found
[ 19.882907] ppdev: user-space parallel port driver
[ 22.251803] eth0: link down
[
[ 38.816071] Kill switch must be turned off for wireless networking
to work.
22.252615] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 38.816066] iwl3945 0000:02:00.0: Radio Frequency Kill Switch is On