Re: OT: SE Z1010 come modem....
Giovanni Mascellani wrote:
>
>
>
> Prova a mandarci gli output di "ifconfig" e "route -n" prima, durante e
> dopo la connessione.
> Gio.
> --
>
>
Grazie per la risposta.....
ifconfig da questo:
debian:~# ifconfig
eth0 Link encap:Ethernet HWaddr 00:C0:9F:F2:FF:15
inet addr:160.97.39.151 Bcast:160.97.39.255 Mask:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:50 Base address:0x5000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:125 errors:0 dropped:0 overruns:0 frame:0
TX packets:125 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:10389 (10.1 KiB) TX bytes:10389 (10.1 KiB)
ppp0 Link encap:Point-to-Point Protocol
inet addr:83.224.152.204 P-t-P:10.64.64.64 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:4 errors:0 dropped:0 overruns:0 frame:0
TX packets:5 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:58 (58.0 b) TX bytes:85 (85.0 b)
Mentre route -n da:
debian:~# route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
10.64.64.64 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0
160.97.39.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
0.0.0.0 160.97.39.254 0.0.0.0 UG 0 0 0 eth0
Pensi possa esserci qualcosa di strano??
--
View this message in context: http://www.nabble.com/SE-Z1010-come-modem....-tf4226284.html#a12051642
Sent from the debian-italian mailing list archive at Nabble.com.
Reply to: