Re: Problema di rete/internet
Mi ero dimenticato di dirvi che come setaggi ho tutto
manuale. Niente dhcp. Il router lo supporta ma ho
preferito lasciarlo disabilitato.
Aspetto vostri suggerimenti.
Ciao e grazie mille dell'attenzione!
Matteo
> Ecco il file ETH.txt
>
>
> > Matteo Piccolo wrote:
> > da root
> >
> > # ifconfig >> ETH.txt
> >
> > # ifconfig eth0 up >> ETH.txt
> >
> > # ifconfig >> ETH.txt
> >
> > # lspci >> ETH.txt
> >
> > # dmesg >> ETH.txt
> >
> > manda ETH.txt in lista
> >
> > Alessandro
> >
> >
> > --
> > Per REVOCARE l'iscrizione alla lista, inviare un
> > email a
> > debian-italian-REQUEST@lists.debian.org con
> oggetto
> > "unsubscribe". Per
> > problemi inviare un email in INGLESE a
> > listmaster@lists.debian.org
> >
> > To UNSUBSCRIBE, email to
> > debian-italian-REQUEST@lists.debian.org
> > with a subject of "unsubscribe". Trouble? Contact
> > listmaster@lists.debian.org
> >
> >
>
>
>
> ___________________________________
> Yahoo! Messenger with Voice: chiama da PC a telefono
> a tariffe esclusive
> http://it.messenger.yahoo.com> lo Link
encap:Local Loopback
> inet addr:127.0.0.1 Mask:255.0.0.0
> inet6 addr: ::1/128 Scope:Host
> UP LOOPBACK RUNNING MTU:16436 Metric:1
> RX packets:586 errors:0 dropped:0
> overruns:0 frame:0
> TX packets:586 errors:0 dropped:0
> overruns:0 carrier:0
> collisions:0 txqueuelen:0
> RX bytes:138711 (135.4 KiB) TX
> bytes:138711 (135.4 KiB)
>
> eth0 Link encap:Ethernet HWaddr
> 00:02:44:56:40:85
> inet6 addr: fe80::202:44ff:fe56:4085/64
> Scope:Link
> UP BROADCAST RUNNING MULTICAST MTU:1500
> Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0
> frame:0
> TX packets:4 errors:0 dropped:0 overruns:0
> carrier:0
> collisions:0 txqueuelen:1000
> RX bytes:0 (0.0 b) TX bytes:328 (328.0 b)
> Interrupt:11 Base address:0xa400
>
> lo Link encap:Local Loopback
> inet addr:127.0.0.1 Mask:255.0.0.0
> inet6 addr: ::1/128 Scope:Host
> UP LOOPBACK RUNNING MTU:16436 Metric:1
> RX packets:691 errors:0 dropped:0
> overruns:0 frame:0
> TX packets:691 errors:0 dropped:0
> overruns:0 carrier:0
> collisions:0 txqueuelen:0
> RX bytes:171666 (167.6 KiB) TX
> bytes:171666 (167.6 KiB)
>
> 0000:00:00.0 Host bridge: VIA Technologies, Inc.
> VT8363/8365 [KT133/KM133] (rev 81)
> 0000:00:01.0 PCI bridge: VIA Technologies, Inc.
> VT8363/8365 [KT133/KM133 AGP]
> 0000:00:07.0 ISA bridge: VIA Technologies, Inc.
> VT82C686 [Apollo Super South] (rev 40)
> 0000:00:07.1 IDE interface: VIA Technologies, Inc.
> VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master
> IDE (rev 06)
> 0000:00:07.2 USB Controller: VIA Technologies, Inc.
> VT82xxxxx UHCI USB 1.1 Controller (rev 16)
> 0000:00:07.3 USB Controller: VIA Technologies, Inc.
> VT82xxxxx UHCI USB 1.1 Controller (rev 16)
> 0000:00:07.4 Bridge: VIA Technologies, Inc. VT82C686
> [Apollo Super ACPI] (rev 40)
> 0000:00:07.5 Multimedia audio controller: VIA
> Technologies, Inc. VT82C686 AC97 Audio Controller
> (rev 50)
> 0000:00:0d.0 Ethernet controller: MYSON Technology
> Inc SURECOM EP-320X-S 100/10M Ethernet PCI Adapter
> 0000:01:00.0 VGA compatible controller: nVidia
> Corporation NV5M64 [RIVA TNT2 Model 64/Model 64 Pro]
> (rev 15)
> Linux version 2.6.15-1-486 (Debian 2.6.15-8)
> (waldi@debian.org) (gcc version 4.0.3 20060212
> (prerelease) (Debian 4.0.2-9)) #2 Mon Mar 6 15:19:16
> UTC 2006
> BIOS-provided physical RAM map:
> BIOS-e820: 0000000000000000 - 000000000009fc00
> (usable)
> BIOS-e820: 000000000009fc00 - 00000000000a0000
> (reserved)
> BIOS-e820: 00000000000f0000 - 0000000000100000
> (reserved)
> BIOS-e820: 0000000000100000 - 0000000017ffc000
> (usable)
> BIOS-e820: 0000000017ffc000 - 0000000017fff000
> (ACPI data)
> BIOS-e820: 0000000017fff000 - 0000000018000000
> (ACPI NVS)
> BIOS-e820: 00000000ffff0000 - 0000000100000000
> (reserved)
> 383MB LOWMEM available.
> On node 0 totalpages: 98300
> DMA zone: 4096 pages, LIFO batch:0
> DMA32 zone: 0 pages, LIFO batch:0
> Normal zone: 94204 pages, LIFO batch:31
> HighMem zone: 0 pages, LIFO batch:0
> DMI 2.3 present.
> ACPI: RSDP (v000 ASUS
> ) @ 0x000f6b20
> ACPI: RSDT (v001 ASUS A7VI-VM 0x30303031 MSFT
> 0x31313031) @ 0x17ffc000
> ACPI: FADT (v001 ASUS A7VI-VM 0x30303031 MSFT
> 0x31313031) @ 0x17ffc080
> ACPI: BOOT (v001 ASUS A7VI-VM 0x30303031 MSFT
> 0x31313031) @ 0x17ffc040
> ACPI: DSDT (v001 ASUS A7VI-VM 0x00001000 MSFT
> 0x0100000b) @ 0x00000000
> ACPI: PM-Timer IO Port: 0xe408
> Allocating PCI resources starting at 20000000 (gap:
> 18000000:e7ff0000)
> Built 1 zonelists
> Kernel command line: root=/dev/hda1 ro
> Local APIC disabled by BIOS -- you can enable it
> with "lapic"
> mapped APIC to ffffd000 (01302000)
> Initializing CPU#0
> PID hash table entries: 2048 (order: 11, 32768
> bytes)
> Detected 1009.424 MHz processor.
> Using pmtmr for high-res timesource
> Console: colour VGA+ 80x25
> Dentry cache hash table entries: 65536 (order: 6,
> 262144 bytes)
> Inode-cache hash table entries: 32768 (order: 5,
> 131072 bytes)
> Memory: 385520k/393200k available (1516k kernel
> code, 7108k reserved, 574k data, 228k init, 0k
> highmem)
> Checking if this processor honours the WP bit even
> in supervisor mode... Ok.
> Calibrating delay using timer specific routine..
> 2019.40 BogoMIPS (lpj=1009704)
> Security Framework v1.0.0 initialized
> SELinux: Disabled at boot.
> Capability LSM initialized
> Mount-cache hash table entries: 512
> CPU: After generic identify, caps: 0183f9ff c1c7f9ff
> 00000000 00000000 00000000 00000000 00000000
> CPU: After vendor identify, caps: 0183f9ff c1c7f9ff
> 00000000 00000000 00000000 00000000 00000000
> CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K
> (64 bytes/line)
> CPU: L2 Cache: 256K (64 bytes/line)
> CPU: After all inits, caps: 0183f9ff c1c7f9ff
> 00000000 00000020 00000000 00000000 00000000
> mtrr: v2.0 (20020519)
> CPU: AMD Athlon(tm) Processor stepping 02
> Enabling fast FPU save and restore... done.
> Checking 'hlt' instruction... OK.
> ACPI: setting ELCR to 0200 (from 0c20)
> checking if image is initramfs... it is
> Freeing initrd memory: 1025k freed
> NET: Registered protocol family 16
> EISA bus registered
> ACPI: bus type pci registered
> PCI: PCI BIOS revision 2.10 entry at 0xf10b0, last
> bus=1
> PCI: Using configuration type 1
> ACPI: Subsystem revision 20050902
> ACPI: Interpreter enabled
> ACPI: Using PIC for interrupt routing
> ACPI: PCI Interrupt Link [LNKA] (IRQs 3 4 5 6 7 9 10
> *11 12 14 15)
> ACPI: PCI Interrupt Link [LNKB] (IRQs 3 4 5 6 7 9 10
> 11 12 14 15) *0, disabled.
> ACPI: PCI Interrupt Link [LNKC] (IRQs 3 4 5 6 7 9
> *10 11 12 14 15)
> ACPI: PCI Interrupt Link [LNKD] (IRQs 3 4 *5 6 7 9
> 10 11 12 14 15)
> ACPI: PCI Root Bridge [PCI0] (0000:00)
> PCI: Probing PCI hardware (bus 00)
> ACPI: Assume root bridge [\_SB_.PCI0] bus is 0
> PCI quirk: region e200-e27f claimed by vt82c686
> HW-mon
> PCI quirk: region e800-e80f claimed by vt82c686 SMB
> Boot video device is 0000:01:00.0
> ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
> ACPI: PCI Interrupt Routing Table
> [\_SB_.PCI0.PCI1._PRT]
> Linux Plug and Play Support v0.97 (c) Adam Belay
> pnp: PnP ACPI init
> pnp: PnP ACPI: found 13 devices
> PnPBIOS: Disabled by ACPI PNP
> PCI: Using ACPI for IRQ routing
> PCI: If a device doesn't work, try "pci=routeirq".
> If it helps, post a report
> pnp: 00:02: ioport range 0xe400-0xe47f could not be
> reserved
> pnp: 00:02: ioport range 0xe800-0xe80f has been
> reserved
> pnp: 00:02: ioport range 0xe200-0xe27f has been
> reserved
> PCI: Bridge: 0000:00:01.0
> IO window: disabled.
> MEM window: f8000000-f9dfffff
> PREFETCH window: f9f00000-fbffffff
> PCI: Setting latency timer of device 0000:00:01.0 to
> 64
> Simple Boot Flag at 0x3a set to 0x1
> audit: initializing netlink socket (disabled)
> audit(1144347364.391:1): initialized
> VFS: Disk quotas dquot_6.5.1
> Dquot-cache hash table entries: 1024 (order 0, 4096
> bytes)
> Initializing Cryptographic API
> io scheduler noop registered
> io scheduler anticipatory registered
> io scheduler deadline registered
> io scheduler cfq registered
> Applying VIA southbridge workaround.
> PCI: Disabling Via external APIC routing
>
=== message truncated ===
___________________________________
Yahoo! Mail: gratis 1GB per i messaggi e allegati da 10MB
http://mail.yahoo.it
Reply to: