Re: Locking Network At 100base T
Thanks
I added options=12 while configuring the card driver using modconf and it
works great.
Thanks a lot
WFT
----- Original Message -----
From: "Enrico Rossi" <e.rossi@adgb.df.unibo.it>
To: "Wilson Tuma" <wilson@douala1.com>
Cc: <>
Sent: Monday, February 28, 2000 5:05 AM
Subject: Re: Locking Network At 100base T
>
> On Sun, 20 Feb 2000, Wilson Tuma wrote:
>
> > my network runs on 3com 3c905b-Tx Cards (does dual speed 10/100). as
well as 3coms superstack II dual speed hub. But I have never suceeded in
making the network run at 100base T. Is there a way using debian to lock the
speed of the network cards at 100base T?
>
> Yes, if you don't set anything the dual speed net card and the hub work in
> 10 Mbps.
> If you are using external module for the net card (3c59x.o) then you must
> add and option=12 in /etc/modules (deb 2.1 stable) or where you load that
> module!
> If you have compiled-in kernel module then you must specify that options
> in lilo.conf.
>
> >From vortex.txt in the kernel doc.
> **********************************
>
> This document describes the usage and errata of the 3Com "Vortex" device
> driver for Linux.
>
> This driver supports the following hardware:
> 3c590, 3c592, 3c595, 3c597
>
> When loaded as a module the following variables may be set:
> name type description
> debug int The debug message level, 0 (no messages) to 6 (wordy).
> options int[] The media type override and card operation settings
> (See list below.)
>
> An example of loading the vortex module is
> insmod 3c59x.o debug=1 options=0,,12
> This sets the debug message level to minimal messages, sets the first card
> to
> the 10baseT transceiver, the second to the EEPROM-set transceiver, and the
> third card to operate in full-duplex mode using its 100baseTx transceiver.
> (Note: card ordering is set by the PCI BIOS.)
>
> Possible media type settings
> 0 10baseT
> 1 10Mbs AUI
> 2 undefined
> 3 10base2 (BNC)
> 4 100base-TX
> 5 100base-FX
> 6 MII (not yet available)
> 7 <Use default setting>
>
> 8 Full-duplex bit
> 8 10baseT full-duplex
> 12 100baseTx full-duplex
> 16 Bus-master enable bit (experimental use only!)
>
> Details of the device driver implementation are at the top of the source
> file.
> *************************************************
>
>
> Hope this help
>
> Bye
>
>
> --
> To UNSUBSCRIBE, email to debian-isp-request@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact
listmaster@lists.debian.org
>
Reply to: