Re: Hurd and the archive
On 08/05/13 00:07, Samuel Thibault wrote:
> I don't know what ethernet driver these would need.
Should probably start a GNU/Hurd hardware status page on the Wiki...
> Neil McGovern, le Tue 07 May 2013 11:14:01 +0100, a écrit :
>> a) A HP DL360 or similar
The chipset has changed a bit between generations:
G1: eepro (Linux) or fxp (*BSD) driver, requiring non-free microcode
G2: HP NC7780 aka BCM5701, tg3 driver (Linux) or bge (*BSD)
G3: HP NC7781, same?
G4: HP NC7782, same?
G5: bce/bnx (*BSD) or bnx2 (Linux) driver, needs non-free blob?
004:00:0: Broadcom BCM5708 NetXtreme II 1000baseT Ethernet (ethernet
network, revision 0x12)
G6: HP NC382i aka BCM5709C, same driver
>> b) A Dell inspiron 660s or similar
Chipset isn't mentioned in their tech specs, perhaps varies.
>> c) A Lenovo Thinkpad X220 or similar
I've seen e1000e mentioned, supported in wheezy by Linux 3.2.x, but not
by the version of the Intel drivers in squeeze:
00:19.0 Ethernet controller: Intel Corporation 82579LM Gigabit Network
Connection (rev 04)
>> d) VMWare/VBox etc.
>
> This already works.
>
> Also, Xen support just works [...]
With network connectivity? If so which NIC do they emulate? (rtl8139?)
What kind of storage bus is used?
Regards,
--
Steven Chamberlain
steven@pyro.eu.org
Reply to: