OSKit-Mach boot failure
Hello All,
First off, I'm not sure this is the correct venue for this topic, so if I
should post to help-hurd, hurd-devel or some other list, please let me
know.
I've built OSKit-Mach and have attempted to install it on my machine which
is an AMD K7 with a VIA VT82C586B main board. My main reason for this is
that with the default kernel, I am unable to see my second onboard ide
controller, which is a Promise PDC202xx, with the default kernel. During
my searches it appeared to me that Joachim Nilsson had worked on a patch
for ATA100 support, and I hoped that by it's absense on his hurd page,
http://hurd.gnufans.org/bin/view/Hurd/JoachimNilssonHurdPage that it was
now in cvs.
Unfortunatly oskit-mach does not load for me at all. My initial build
included no debug suppport, so I don't have much info on this other than
the console output.
Welcome to GNU Mach 1.91!
Kernel page fault at address 0x1, eip = 0x1
Kernel Page fault trap, eip 0x1
kernel trap, type 14, code = 0
Dump of trap_state at 0x002aafb8:
EAX 0000dfdf EBX 00117930 ECX 00000007 EDX 00000000
ESI 00000000 EDI 00000000 EBP 218f6fd8 ESP 002aaffc
EIP 00000001 EFLAGS 00010002
CS 0010 SS 0028 DS 0028 ES 0028 FS 0000 GS 0000
trapno 14, error 00000000, from kernel mode
page fault linear address c0000001
c0000001 00000001 00000000 00000000 00000000 00000000 00000000 00000000
00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000
00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000
00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000
trap
Backtrace: fp=2aaf48
0022f049 0013e013 001412cb
_exit(1) called; rebooting...
If anyone has any ideas or pointers please let me know.
Thanks
Chris
Reply to: