Trying to install HURD--Need Help

[John Foster <jfoster@augustmail.com>]

My system is as follows:
Hardware: 
	dual pentium 233-mmx processors
	128 Mb ram
	3 hard drives
		/dev/hda1  13.2Gb   type FAT32  Windows98 C: 
		/dev/hdb1  999.17Mb type Linux ext2 type 83 Primary Boot
					 GRUB root=(hd1,0)  
					 HURD root=hd1s1
		/dev/hdb2  999.17Mb type Linux ext2 type 83 Primary
		/dev/hdb3  999.17Mb type Linux ext2 type 83 Primary
		/dev/hdb4  999.17Mb type Linux ext2 type 82 SWAP
		/dev/hdc1  13.541Gb type Linux ext2 type 83 Primary Boot
		/dev/hdc2  135.22Mb type Linux ext2 type 82 SWAP

I used the system on /dev/hdc1 to set up my drives. It is a Debian Linux
Potato system. I used the instructions for the large tar ball setup. the
mke2fs version on Potato is 1.18. I used all of the files downloaded
from the alpha.gnu.org/gnu/hurd/contrib/marcus/* ftp site. tarball#
gnu-20000301.tar.gz. I used the grub-floppy-19991023 floppy image to
create my boot disk. All of the files are visible and I can read and
write to the ext2 filesystem  when it is mounted on /gnu. I followed the
boot up instructions; used the grub floppy; got the command prompt
grub>; I issued the command "root=(hd1,0)"; recieved the message 'found
ext2 linux filesystem"; I issued the command "kernel=hd1s1 -s";that is
as far as I got. I get the error message "file not found";
ANY help or criticisms are greatly appreciated as this is my first
attempt at using HURD.
-- 
AdVance-Computing Systems

We sell fine quality servers and workstations.
We specialize in multiprocessor units. 
We install Debian Linux at no extra charge!

John Foster                                
jfoster@augustmail.com 
ICQ# 19460173