On 5/23/13 3:36 PM, Helge Deller wrote:
On 05/23/2013 09:09 PM, Dave Land wrote:
Thanks for the reply Helge. I did manage to get it to find the
proper
kernel and boot from it, but I can't get it past the point where it
hands over the boot console to tty0. It *seems* to be up, but I
can't
log in with PUTTY on a remote machine either by SSH or telnet. I
also
tried changing the IPL list to forward it to ttyS0, but nothing
shows
up on Tera-term, plus according to the LED display on the front of
the HP, it seems to have crashed. My IPL list looks something
like this:
0: 2/vmlinux-3.9
1: root=/dev/sda4 (actually correct according to how I partitioned)
2: initrd=2/initrd.img (removed according to instructions)
3: HOME=/
4: panic=-1 (tried with and without)
5: console=tty0
6: sti=10/4/2/0
7: sti_font=VGA8x6
8: TERM=linux
Maybe this may give a little insight to what is going on?
Yes, I have an idea.
I assume your machine is up an running. Just try to ping the
machine.
Are you installing via serial console?
In that case change the value of "console" in IPL to
console=ttyS0 (which is serial port #1)
and change the "TERM=linux" to "TERM=linux 1" (a space between
linux
and 1)
This adds a 9th parameter "1" which instructs the kernel to boot
into
runlevel 1.
If it boots up, you should get a request to enter the root password.
Then remount the root-filesystem read-writeable, e.g. run "mount -o
remount,rw /".
Then uncomment in /etc/inittab this line:
T0:23:respawn:/sbin/getty -L ttyS0 9600 vt100
This instructs init ro spawn a login shell on ttyS0 (=serial
console).
After that reboot again normally.
Helge
LOL, the mystery gets deeper. I tried the ttyS0 serial console edit
again (it crashed the machine before), and added the extra line
with '1'
in it for run level 1, and once again it crashed, even after removing
the references for the sti console. Incidentally, I'm normally
booting
to a graphics console, not serial...
So I booted back up with my old kernel and went in and edited
/etc/inittab and uncommented T0:23:respawn:/sbin/getty -L ttys0 9600
vt100 and went back and tried it again, and once again it crashed
when
it tried to switch to the serial terminal. So I rebooted with my old
kernel once again, and lo & behold, when I got to the login prompt, I
also had a login prompt on my serial terminal too... and both of them
work. Still doesn't do me much good with the new kernel, but I
thought
it was kind of interesting that I have tty0 and ttyS0
simultaneously on
the old kernel (2.6.26-2).
I've got one more thing to try, and that is remove the graphics
card and
boot it, and see if the firmware will default to the serial terminal.
Maybe then I can get it to play nice until I do the apt-get upgrade.
Theoretically, I should be able to get it to see the graphics card
once
the upgrade is finished and I reboot. I'll let you know what happens.
Thanks for all your help.