Re: Hyperlatex default emacs key bindings for Debian
Roland Stigge <stigge@antcom.de> wrote:
> On Wed, 2003-08-13 at 17:24, Roland Stigge wrote:
> > +(eval-after-load "latex"
> > + (add-to-list 'after-load-alist
> > + '("latex" (define-key LaTeX-mode-map
> > + (kbd "C-c C-c h")
> > + 'hyperlatex-format-buffer)))
> > + (define-key LaTeX-mode-map
> > + (kbd "C-c C-c h")
> > + 'hyperlatex-format-buffer))
> > ======================================================================
>
> Or even better:
>
> ======================================================================
> --- debian/42hyperlatex.el 2003-05-19 15:25:18.000000000 +0200
> +++ debian/42hyperlatex.el.new 2003-08-10 18:14:08.000000000 +0200
> @@ -5,4 +5,11 @@
> (parse-colon-path (getenv "HYPERLATEX_DIR"))))
> (autoload 'hyperlatex-format-buffer "hyperlatex/hyperlatex"
> "Process the current buffer as hyperlatex code, into a Html
> document." t)
> -(global-set-key "\C-ch" 'hyperlatex-format-buffer)
> +(eval-after-load "latex"
> + '(add-to-list 'after-load-alist
> + '("latex" (define-key LaTeX-mode-map
> + (kbd "C-c C-c h")
> + 'hyperlatex-format-buffer)))
> + (define-key LaTeX-mode-map
> + (kbd "C-c C-c h")
> + 'hyperlatex-format-buffer))
> ======================================================================
>
> :)
>
> ?
No, not really. `eval-after-load' will by itself hack the
after-load-list or run the code now if the file is already loaded. So
something like:
(eval-after-load "latex"
'(define-key LaTeX-mode-map "\C-c\C-ch" 'hyperlatex-format-buffer))
But use a different key again. C-c C-c is already used in AUC-TeX's
LaTeX-mode-map:
C-c C-c runs the command TeX-command-master
Peter
Reply to: