Re: Problem mit usb-Platten an Sarge-Tjener

[Florian Reitmeir <florian@reitmeir.org>]

Hi,

ich tippe auf 2 moegliche Ursachen:
- defekte Festplatte (das kann man mit den smartmontools genauer
	herausfinden)
- buggy Festplatten Firmware

Fuer ersteres, die smartmontools installieren und den Status der Platten
damit ansehen.

Fuer zweiteres hilft eigentlich nur ein Kernel Upgrade+Glueck


On Wed, 09 May 2007, Frank Weißer wrote:

> usb 3-4: new high speed USB device using ehci_hcd and address 3
> usb 3-4: configuration #1 chosen from 1 choice
> scsi1 : SCSI emulation for USB Mass Storage devices
> usb-storage: device found at 3
> usb-storage: waiting for device to settle before scanning
>   Vendor: WDC WD25  Model: 00BB-00RDA0       Rev:  0 0
>   Type:   Direct-Access                      ANSI SCSI revision: 00
> SCSI device sda: 488397168 512-byte hdwr sectors (250059 MB)
> sda: Write Protect is off
> sda: Mode Sense: 03 00 00 00
> sda: assuming drive cache: write through
> SCSI device sda: 488397168 512-byte hdwr sectors (250059 MB)
> sda: Write Protect is off
> sda: Mode Sense: 03 00 00 00
> sda: assuming drive cache: write through
>  sda:<6>sd 1:0:0:0: SCSI error: return code = 0x10070000
> end_request: I/O error, dev sda, sector 0
> printk: 32 messages suppressed.
> Buffer I/O error on device sda, logical block 0
> sd 1:0:0:0: SCSI error: return code = 0x10070000
> end_request: I/O error, dev sda, sector 0
> Buffer I/O error on device sda, logical block 0
>  unable to read partition table

-- 
Florian Reitmeir