Bug#510060: installation report for lenny d-i rc1 on silicon graphics O2

[Martin Michlmayr <tbm@cyrius.com>]

* Giuseppe Sacco <giuseppe@eppesuigoccas.homedns.org> [2008-12-29 01:36]:
> ... installation goes to the end and print this message about PROM:
> 
>   x    setenv SystemPartition scsi(0)disk(1)rdisk(0)partition(8)          a x   
>   x    setenv OSLoadPartition scsi(0)disk(1)rdisk(0)partition(0)          a x   
>   x    setenv OSLoader arcboot                                            a x   
>   x    setenv OSLoadFilename Linux                                        a x   
> 
> then rebooted the machine, but I found that first two variables are
> missing a "pci(0)" in front. Correct values seems to be:
> setenv SystemPartition pci(0)scsi(0)disk(1)rdisk(0)partition(8)
> setenv OSLoadPartition pci(0)scsi(0)disk(1)rdisk(0)partition(0)

I'm pretty sure it worked without pci(0) for me.  I guess you need the
pci(0) because your O2 has some PCI cards in it whereas mine didn't.
Thomas, do you think this is correct?  And is the SCSI controller
always pci(0)?  If so, I can add this to the message.
-- 
Martin Michlmayr
http://www.cyrius.com/