Package: installation-reports
Boot method: Network install using serial console
boot: install console=ttyS0,17200
Image version: ftp://ftp.uk.debian.org/debian/dists/etch/main/installer-i386/20070308etch1/images/netboot/mini.iso
or: ftp://ftp.uk.debian.org/debian/dists/etch/main/installer-i386/20070308/images/netboot/mini.iso
Date: 2007/10/08 10:00 +0100
Machine: Dell PowerEdge SC 1425
Processor: Intel(R) Xeon(TM) CPU 2.80GHz
Memory: 516644k
Partitions:
Disk /dev/sda: 80.0 GB, 80000000000 bytes
255 heads, 63 sectors/track, 9726 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/sda1 * 1 243 1951866 83 Linux
/dev/sda2 244 9726 76172197+ 5 Extended
/dev/sda5 244 1459 9767488+ 83 Linux
/dev/sda6 1460 2675 9767488+ 83 Linux
/dev/sda7 2676 3891 9767488+ 83 Linux
/dev/sda8 3892 4499 4883728+ 82 Linux swap / Solaris
/dev/sda9 4500 4864 2931831 83 Linux
/dev/sda10 4865 6080 9767488+ 83 Linux
/dev/sda11 6081 7296 9767488+ 83 Linux
/dev/sda12 7297 8512 9767488+ 83 Linux
/dev/sda13 8513 9726 9751423+ 83 Linux
Output of lspci -nn and lspci -vnn:
# lspci -nn
00:00.0 Host bridge [0600]: Intel Corporation E7520 Memory Controller Hub [8086:3590] (rev 09)
00:02.0 PCI bridge [0604]: Intel Corporation E7525/E7520/E7320 PCI Express Port A [8086:3595] (rev 09)
00:1d.0 USB Controller [0c03]: Intel Corporation 82801EB/ER (ICH5/ICH5R) USB UHCI Controller #1 [8086:24d2] (rev 02)
00:1d.1 USB Controller [0c03]: Intel Corporation 82801EB/ER (ICH5/ICH5R) USB UHCI Controller #2 [8086:24d4] (rev 02)
00:1d.7 USB Controller [0c03]: Intel Corporation 82801EB/ER (ICH5/ICH5R) USB2 EHCI Controller [8086:24dd] (rev 02)
00:1e.0 PCI bridge [0604]: Intel Corporation 82801 PCI Bridge [8086:244e] (rev c2)
00:1f.0 ISA bridge [0601]: Intel Corporation 82801EB/ER (ICH5/ICH5R) LPC Interface Bridge [8086:24d0] (rev 02)
00:1f.1 IDE interface [0101]: Intel Corporation 82801EB/ER (ICH5/ICH5R) IDE Controller [8086:24db] (rev 02)
00:1f.2 IDE interface [0101]: Intel Corporation 82801EB (ICH5) SATA Controller [8086:24d1] (rev 02)
01:00.0 PCI bridge [0604]: Intel Corporation 6700PXH PCI Express-to-PCI Bridge A [8086:0329] (rev 09)
01:00.1 PIC [0800]: Intel Corporation 6700/6702PXH I/OxAPIC Interrupt Controller A [8086:0326] (rev 09)
01:00.2 PCI bridge [0604]: Intel Corporation 6700PXH PCI Express-to-PCI Bridge B [8086:032a] (rev 09)
01:00.3 PIC [0800]: Intel Corporation 6700PXH I/OxAPIC Interrupt Controller B [8086:0327] (rev 09)
02:04.0 Ethernet controller [0200]: Intel Corporation 82541GI/PI Gigabit Ethernet Controller [8086:1076] (rev 05)
04:03.0 Ethernet controller [0200]: Intel Corporation 82541GI/PI Gigabit Ethernet Controller [8086:1076] (rev 05)
04:0d.0 VGA compatible controller [0300]: ATI Technologies Inc Radeon RV100 QY [Radeon 7000/VE] [1002:5159]
# lspci -vnn
00:00.0 Host bridge [0600]: Intel Corporation E7520 Memory Controller Hub [8086:3590] (rev 09)
Subsystem: Dell PowerEdge SC1425 [1028:019a]
Flags: bus master, fast devsel, latency 0
Capabilities: [40] Vendor Specific Information
00:02.0 PCI bridge [0604]: Intel Corporation E7525/E7520/E7320 PCI Express Port A [8086:3595] (rev 09) (prog-if 00 [Normal decode])
Flags: bus master, fast devsel, latency 0
Bus: primary=00, secondary=01, subordinate=03, sec-latency=0
I/O behind bridge: 0000e000-0000efff
Memory behind bridge: dfb00000-dfefffff
Capabilities: [50] Power Management version 2
Capabilities: [58] Message Signalled Interrupts: Mask- 64bit- Queue=0/1 Enable-
Capabilities: [64] Express Root Port (Slot-) IRQ 0
Capabilities: [100] Advanced Error Reporting
00:1d.0 USB Controller [0c03]: Intel Corporation 82801EB/ER (ICH5/ICH5R) USB UHCI Controller #1 [8086:24d2] (rev 02) (prog-if 00 [UHCI])
Subsystem: Dell PowerEdge SC1425 [1028:019a]
Flags: bus master, medium devsel, latency 0, IRQ 169
I/O ports at cce0 [size=32]
00:1d.1 USB Controller [0c03]: Intel Corporation 82801EB/ER (ICH5/ICH5R) USB UHCI Controller #2 [8086:24d4] (rev 02) (prog-if 00 [UHCI])
Subsystem: Dell PowerEdge SC1425 [1028:019a]
Flags: bus master, medium devsel, latency 0, IRQ 185
I/O ports at ccc0 [size=32]
00:1d.7 USB Controller [0c03]: Intel Corporation 82801EB/ER (ICH5/ICH5R) USB2 EHCI Controller [8086:24dd] (rev 02) (prog-if 20 [EHCI])
Subsystem: Dell PowerEdge SC1425 [1028:019a]
Flags: bus master, medium devsel, latency 0, IRQ 201
Memory at dff00000 (32-bit, non-prefetchable) [size=1K]
Capabilities: [50] Power Management version 2
Capabilities: [58] Debug port
00:1e.0 PCI bridge [0604]: Intel Corporation 82801 PCI Bridge [8086:244e] (rev c2) (prog-if 00 [Normal decode])
Flags: bus master, fast devsel, latency 0
Bus: primary=00, secondary=04, subordinate=04, sec-latency=32
I/O behind bridge: 0000d000-0000dfff
Memory behind bridge: df900000-dfafffff
Prefetchable memory behind bridge: d0000000-d7ffffff
00:1f.0 ISA bridge [0601]: Intel Corporation 82801EB/ER (ICH5/ICH5R) LPC Interface Bridge [8086:24d0] (rev 02)
Flags: bus master, medium devsel, latency 0
00:1f.1 IDE interface [0101]: Intel Corporation 82801EB/ER (ICH5/ICH5R) IDE Controller [8086:24db] (rev 02) (prog-if 8a [Master SecP PriP])
Subsystem: Dell PowerEdge SC1425 [1028:019a]
Flags: bus master, medium devsel, latency 0, IRQ 209
I/O ports at <unassigned>
I/O ports at <unassigned>
I/O ports at <unassigned>
I/O ports at <unassigned>
I/O ports at fc00 [size=16]
Memory at 20000000 (32-bit, non-prefetchable) [size=1K]
00:1f.2 IDE interface [0101]: Intel Corporation 82801EB (ICH5) SATA Controller [8086:24d1] (rev 02) (prog-if 8f [Master SecP SecO PriP PriO])
Subsystem: Dell PowerEdge SC1425 [1028:019a]
Flags: bus master, 66MHz, medium devsel, latency 0, IRQ 209
I/O ports at ccb8 [size=8]
I/O ports at ccb0 [size=4]
I/O ports at cca0 [size=8]
I/O ports at cc98 [size=4]
I/O ports at cc80 [size=16]
01:00.0 PCI bridge [0604]: Intel Corporation 6700PXH PCI Express-to-PCI Bridge A [8086:0329] (rev 09) (prog-if 00 [Normal decode])
Flags: bus master, fast devsel, latency 0
Bus: primary=01, secondary=02, subordinate=02, sec-latency=32
I/O behind bridge: 0000e000-0000efff
Memory behind bridge: dfd00000-dfefffff
Capabilities: [44] Express PCI/PCI-X Bridge IRQ 0
Capabilities: [5c] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable-
Capabilities: [6c] Power Management version 2
Capabilities: [d8] PCI-X bridge device
Capabilities: [100] Advanced Error Reporting
Capabilities: [300] Power Budgeting
01:00.1 PIC [0800]: Intel Corporation 6700/6702PXH I/OxAPIC Interrupt Controller A [8086:0326] (rev 09) (prog-if 20 [IO(X)-APIC])
Flags: bus master, fast devsel, latency 0
Memory at dfbff000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [44] Express Endpoint IRQ 0
Capabilities: [6c] Power Management version 2
01:00.2 PCI bridge [0604]: Intel Corporation 6700PXH PCI Express-to-PCI Bridge B [8086:032a] (rev 09) (prog-if 00 [Normal decode])
Flags: bus master, fast devsel, latency 0
Bus: primary=01, secondary=03, subordinate=03, sec-latency=64
Capabilities: [44] Express PCI/PCI-X Bridge IRQ 0
Capabilities: [5c] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable-
Capabilities: [6c] Power Management version 2
Capabilities: [d8] PCI-X bridge device
Capabilities: [100] Advanced Error Reporting
Capabilities: [300] Power Budgeting
01:00.3 PIC [0800]: Intel Corporation 6700PXH I/OxAPIC Interrupt Controller B [8086:0327] (rev 09) (prog-if 20 [IO(X)-APIC])
Flags: bus master, fast devsel, latency 0
Memory at dfbfe000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [44] Express Endpoint IRQ 0
Capabilities: [6c] Power Management version 2
02:04.0 Ethernet controller [0200]: Intel Corporation 82541GI/PI Gigabit Ethernet Controller [8086:1076] (rev 05)
Subsystem: Dell PowerEdge SC1425 [1028:019a]
Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 177
Memory at dfde0000 (32-bit, non-prefetchable) [size=128K]
I/O ports at ecc0 [size=64]
Capabilities: [dc] Power Management version 2
Capabilities: [e4] PCI-X non-bridge device
04:03.0 Ethernet controller [0200]: Intel Corporation 82541GI/PI Gigabit Ethernet Controller [8086:1076] (rev 05)
Subsystem: Dell PowerEdge SC1425 [1028:019a]
Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 193
Memory at df9e0000 (32-bit, non-prefetchable) [size=128K]
I/O ports at dcc0 [size=64]
Capabilities: [dc] Power Management version 2
Capabilities: [e4] PCI-X non-bridge device
04:0d.0 VGA compatible controller [0300]: ATI Technologies Inc Radeon RV100 QY [Radeon 7000/VE] [1002:5159] (prog-if 00 [VGA])
Subsystem: Dell PowerEdge SC1425 [1028:019a]
Flags: bus master, VGA palette snoop, stepping, medium devsel, latency 32, IRQ 11
Memory at d0000000 (32-bit, prefetchable) [size=128M]
I/O ports at d800 [size=256]
Memory at df9d0000 (32-bit, non-prefetchable) [size=64K]
[virtual] Expansion ROM at df900000 [disabled] [size=128K]
Capabilities: [50] Power Management version 2
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [O]
Detect network card: [O]
Configure network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Install base system: [O]
Clock/timezone setup: [O]
User/password setup: [O]
Install tasks: [O]
Install boot loader: [O]
Overall install: [O]
Comments/Problems:
The system booted just fine, but GRUB had bein configued with the following
at the top of /boot/grub/menu.lst:
serial --unit=0 --speed=19200 --word=console=ttyS0,19200 --parity= --stop=1
terminal serial
As the word and parity are not configured correctly GRUB still worked but
sent it's output to the attached monitor not to the serial port.
I changed the top line to:
serial --unit=0 --speed=19200 --word=8 --parity=no --stop=1
and GRUB then worked as expected.
Steve
Attachment:
signature.asc
Description: Digital signature