Bug#338975: Package: installation-reports (CG11132005) - FAILED
Package: installation-reports
Debian-installer-version: Debian GNU/Linux 3.1 r0a "Sarge" - Official
i386 Binary-1
Downloaded on 13-Nov-2005 from
http://cdimage.debian.org/debian-cd/3.1_r0a/i386/iso-cd/debian-31r0a-i386-netinst.iso
uname -a: Linux (none) 2.4.27-2-386 #1 Thu Jan 20 10:55:08 JST 2005 i686
unknown
Date: 13-Nov-2005 12:00 PM EDT
Method: Used official netinst image for the "stable" release burned to a
CD used to boot from.
Machine: HP Pavillion zv5240ca Laptop 55 GB Harddrive (19 used for
"Workstation" standard debian partitions)
Processor: Pentium 4 3.00 GHz
Memory: 640 MB RAM
Root Device: IDE: FUJITSU MHT2060AT PL, ATA DISK Drive
Root Size/partition table:
IDE1 master (hda) - 60.0 GB FUJITSU MHT2060AT PL
#1 primary 41.9 GB ntfs (my existing XP Pro partition)
#2 primary 17.3 GB ext3
#5 logical 773.1 MB swap
Output of lspci and lspci -n: not found by shell
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [E]
Comments/Problems: Preliminary steps of the installation occurred
without error. However, on the first boot into Debian, I got a kernel
panic, and the boot failed. Here is an excerpt of the install log,
there may be some typos. Debian newbie; any help appreciated!
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ide: late registration of driver.
ATIIXP: IDE controller at PCI slot 00:14.1
ATIIXP: chipset revision 0
ATIIXP: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0x8060-0x8067, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0x8068-0x806f, BIOS settings: hdc:DMA, hdd:pio
hda: FUJITSU MHT2060AT PL, ATA KISK Drive
Unable to handle kernel paging request at virtual address e883a09f
printing eip:
*pde = 016f1067
*pte = 00000000
Oops: 0000
CPU; 0
EIP: 0010:[<e88394ed>] Not tainted
EFLAGS: 00010046
-----a bunch of hex-------
Segmentation fault
<6>Journalled Block Device driver loaded
pivot_root: No such file or directory
/sbin/init: 432: cannot open dev/console: No such file
Kernel panic: Attempted to kill init!
--
Chris Gantz
BUILDERadius, Incorporated
Tel: 828-350-9950
Fax: 828-350-9954
cgantz@BUILDERadius.com
http://BuildingDepartment.com
Reply to: