On Tue, 2013-12-03 at 15:15 +0000, Ben Hutchings wrote: > On Tue, 2013-12-03 at 08:44 +0000, Ian Campbell wrote: > > On Tue, 2013-12-03 at 09:19 +0800, Niew, Sh. wrote: > > > Hi, > > > > > > I'm install linux-image-3.11-2-armmp in my Boundary Devices SABRELite board, > > > but linux can't mount the SATA drive and there is no AHCI_IMX is not > > > set in config. > > > > It looks like the old imx flavour only had CONFIG_PATA_IMX=m and this > > was carried over to the armmp flavour. It looks like AHCI_IMX was never > > enabled. > > > > I suppose the pata driver isn't working for you? Did you ever try the > > old imx flavour and did it work? > > > > Are there two disk controllers on this platform or do these represent > > two faces of the same hardware port? > > > > In general the move has been from PATA to AHCI, I suppose we ought to > > transition here too? Does AHCI_IMX actually work if enabled? > > AHCI is SATA-only, no? Yes, I think I was confusing SATA and PATA. > We still need separate drivers for any PATA > interfaces. Anyway, please make the necessary config changes to the > armmp flavour (and armmp-lpae if any i.MX chips support LPAE). Will do. Ian.
Description: This is a digitally signed message part