Re: Re: Some help needed to install Lenny on the Intel SS4000-E nas
- To: <debian-arm@lists.debian.org>
- Subject: Re: Re: Some help needed to install Lenny on the Intel SS4000-E nas
- From: "Chris Wilkinson" <kinsham@verizon.net>
- Date: Wed, 11 Jul 2012 09:53:58 -0400
- Message-id: <002d01cd5f6c$9f410e80$ddc32b80$@net>
This post http://lists.debian.org/debian-arm/2009/07/msg00058.html links to
the install instructions at
http://d-i.alioth.debian.org/manual/en.armel/ch05s01.html#boot-firmware-ss40
00e.
There seems to be an error in this latter link. The serial line settings are
115200, 8-bit, no parity, flow-control=none.
The cntrl-c after 'fis load rammode', 'g', doesn't work on the board I have
(an EM-7220 in a Freestor 4020 which is an SS4000-E lookalike). The boot
message to break with cntrl-c never comes up so it just runs on without the
chance to set the ip etc. It hangs up eventually.
EM-438/EM-7220 ver.AG0 2006-05-23
== Executing boot script in 1.000 seconds - enter ^C to abort
^C
RedBoot> ^C
RedBoot> fis list
Name FLASH addr Mem addr Length Entry point
RedBoot 0xF0000000 0xF0000000 0x00040000 0x00000000
RedBoot config 0xF07C0000 0xF07C0000 0x00001000 0x00000000
FIS directory 0xF07E0000 0xF07E0000 0x00020000 0x00000000
rammode 0xF0700000 0x00200000 0x00040000 0x00200000
zImage 0xF0040000 0x01008000 0x00200000 0x01008000
ramdisk.gz 0xF0240000 0x01800000 0x00400000 0x01008000
wmdata 0xF0640000 0xF0640000 0x000C0000 0x01008000
naskey 0xF0740000 0xF0740000 0x00020000 0x01008000
log 0xF0760000 0xF0760000 0x00040000 0x01008000
vendor 0xF07A0000 0xF07A0000 0x00020000 0x01008000
RedBoot> fis load rammode
RedBoot> g
+Ethernet eth0: MAC address 00:02:41:00:94:7f
IP: 10.9.9.1/255.255.255.0, Gateway: 10.9.9.1
Default server: 10.9.9.10, DNS server IP: 0.0.0.0
EM-438/EM-7220 2006-07-31 (RAM mode for updating RedBoot)
RedBoot> fis load ramdisk.gz
RedBoot> fis load zImage
RedBoot> exec
Using base address 0x01008000 and length 0x00200000
Uncompressing Linux... done, booting the kernel
-Hangs here-
Also the first load command 'load -v -r -b 0x01800000 -m ymodem ramdisk.gz'
in the link - should this be initrd.gz instead of ramdisk.gz?
There seem to be numerous versions of initrd.gz and zImage about. Can anyone
point at a set they got to work?
CJW
Reply to: